Casals ID600REP Manual De Instrucciones página 7

- To open the drill's chuck, use the chuck key (I)
and rotate it counterclockwise.
- Insert the bit inside the chuck
- Use the chuck key to close the drill chuck and
ensure the drill bit.
Screwing, drilling/unscrewing:
- To drill or screw, ALWAYS have the direction set
to clockwise (CW).
- To unscrew, set the direction to counter clockwise
(CCW).
- The appliance should not be in use when chang-
ing the screwing direction.
How to select the direction of the rotation (Fig
A)
- Do not change the direction of the rotation whilst
the tool motor is in operation.
- The appliance has a selector (D), which allows
the direction of rotation to be changed.
Electronic speed control: (Fig A)
- The speed of the appliance can be regulated
according to the pressure exerted on the on/off
switch (A). This function is very useful, as it makes
it possible to adapt the speed of the appliance to
the type of work that needs to be done.
- If the appliance works continuously at low speed,
working life of the appliance will be reduced con-
siderably.
Select the function (Fig A)
Drilling
- Turn the selector (E) until points to (
Drilling with Impact Function
- Turn the selector (E) until points to (
Use:
- Connect the appliance to the mains.
- Select the appliance function desired.
- Select the desired speed.
- Turn the appliance on, by using the on/off button
(A)
Locking button:
- To activate this function press button (C) while
holding down the start-up switch.
- To deactivate this function press the start-up
switch right down.
Once you have finished using the appliance:
- Stop the appliance by releasing the on/off switch.
- Clean the appliance
Cleaning
ID600REP_IM.indd 7
- Disconnect the appliance from the mains and al-
low it to cool before undertaking any cleaning task.
- Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO NOT IM-
MERSE IN WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp cloth with a few
drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products, for
cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of the
appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of cleanli-
ness, its surface may degrade and inexorably
affect the duration of the appliance's useful life and
could become unsafe to use.
Supplies
- Always use original supplies, designed specifi-
cally for your appliance model.
- These supplies are available in specialist shops.
Anomalies and repair
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If the connection to the mains has been dam-
aged, it must be replaced, take the appliance to
an authorised technical support service. Do not
attempt to disassemble or repair the appliance by
). yourself in order to avoid a hazard.
Specifications:
)
Model
Rated Power
Rated Voltage
Rated Frequency
No load speed
Electronic speed
control
Maximum capacity
Wood:25mm
Masonry:13
Drill Chuck capacity
Reversible
Weight
ID600REP
600W
220-240 V~
50/60 Hz
0-3000 rpm
✓
Steel:13mm
Ø 13mm
✓
2,0 Kg
2019-03-29 01:40:07 PM