Installation Checklist; Tools Required; List Of Tools And Supplies - Honeywell TrueDRY DH65 Guía De Instalación Profesional

Installation Guide

Installation Checklist

Tools Required

- 3/8-in. hex drive
- Drill or duct-cutting tool
- Wire stripper/cutter
- Standard screwdriver
- Duct tape
- 8-in. round duct and starter collar
- 18–22 gauge, 5-band thermostat wire
- 1/2-in. diameter drain line (8 ft)
- 1/2-in. drain clamps (quantity 2)
Materials Provided
- Sheet metal screws (quantity 9)
- 8-in. plastic duct collars (quantity 2)
Options:
- 1/2-in. drain p-trap (may be required by local code)
- External humidity control (only one included)
• Manual dehumidistat (H8908DSPST), Auto
Ventilation (W8150A1000)
• TrueIAQ (DG115EZIAQ)
• VisionPRO IAQ (YTH9421C1010)
WARNING: Installation must be performed by a qualified service technician and must comply with local
codes. Remove power to the device before installing or servicing the device. Failure to connect the
device according to these instructions may result in damage to the device or the controls.
69-2089EFS—01