Wet Pick Up Operation; Blower Feature; Emptying Liquid Waste - Shop-Vac L Serie Manual Del Usuario

WARNING!
FOR FINE DUST POWDERS
When vacuuming fine dust, or powders of any kind
(plaster, drywall dust, cold ashes, concrete dust, etc.)
a high efficiency drywall filter bag must be used. When
vacuuming normal household dust and debris, standard
household disposable filter bags may be used.
WET PICK UP
OPERATION
21. Your vacuum can be used for wet pick up. Remove
ALL dirt and debris found in the tank. Remove all
dry use only filters, including the filter bag, from the
vacuum.
22. Wet pick up requires the foam sleeve to be
in position over the lid cage. To install, follow the
installation instructions in this section.
23. Misting in the exhaust air or dripping of liquid
around the tank cover may occur if the filter becomes
saturated during wet pick up. If this occurs, remove the
filter and allow to dry, or replace with another dry filter.
24. Turn the unit off immediately upon completing a
wet pick up job or when tank is full and ready to be
emptied. When the tank is full, suction will drastically
reduce. Refer to "automatic suction shut off" in this
manual. Raise the hose to drain any excess liquid into
the tank. Follow the "emptying liquid waste" section in
this manual.
25. Before storing the vacuum cleaner or using for dry
pick up, clean and dry the interior of the tank and the
underside of the tank cover. Clean and allow the filters
to dry completely.
NOTE: WET PICK UP ACCESSORIES SHOULD BE
WASHED PERIODICALLY; ESPECIALLY AFTER PICKING
UP WET, STICKY KITCHEN ACCIDENTS. THIS CAN BE
ACCOMPLISHED WITH A WARM SOLUTION OF SOAP
AND WATER.
FOAM SLEEVE INSTALLATION AND CLEANING:
FIGURE 9
26. With tank cover in an
upside down position, slide
foam sleeve down over lid
cage pulling until foam sleeve
completely covers lid cage.
FIGURE 9.
27. To clean the foam sleeve, disconnect the plug from
the wall outlet. Remove the tank cover and place the
cover in an upside-down position. Remove foam sleeve
by sliding it up and off the lid cage.
28. Shake excess debris off of the foam sleeve with a
rapid up and down movement.
29. Hold foam sleeve under running water for a minute
or two, rinsing from the inside of the filer. A water wash
is not always required, depending on the condition of
the foam sleeve.
30. Check the filter for tears. If any are found, replace
with a new filter.
31. Your vacuum can be used as a powerful blower.
To use your unit as a blower, clear hose of any
FIGURE 10
WARNING!
ALWAYS WEAR EYE PROTECTION TO PREVENT
ROCKS OR DEBRIS FROM BEING BLOWN OR
RICOCHETING INTO THE EYES OR FACE WHICH
CAN RESULT IN SERIOUS INJURY.
EMPTYING LIQUID
WASTE FROM THE
TANK
32. Your vacuum can be emptied of liquid waste by
removing the tank cover. To empty, turn unit off and
remove plug from the wall receptacle. Remove the tank
cover and deposit the liquid waste contents in a suitable
drain. After the tank is empty, return the tank cover to
its original position. To continue use, plug the cord into
the wall receptacle and turn the unit on.
BLOWER
FEATURE
obstructions. Insert hose end
into blower port on rear of unit.
FIGURE 10. Twist slightly to
tighten the connection. Caution
should be used when using as
a blower due to the powerful
force of air when using certain
attachments.
PAGE 7