Thank you for choosing a Hozelock quality product.
You can be assured of many years of reliable service
from this product.
THIS APPLIANCE IS FOR HOUSEHOLD
USE. READ THESE INSTRUCTIONS
CAREFULLY BEFORE ATTEMPTING
INSTALLATION.
FAILURE TO OBSERVE THE FOLLOWING NOTICES
MAY RESULT IN INJURY, PRODUCT DAMAGE OR
LOSS OF FISH.
KEEP THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
YOU CAN ALSO DOWNLOAD THESE
INSTRUCTIONS AT http://www.hozelock.com/
customer-service/instruction-leaflets.html.
Contents
(Fig.1) Check all contents are present before
installation.
A. Small Fish Protection Insert
B. Pump
C. Outlet adaptor
D. Ball Joint
E. Hosetail & Nut
F. Strainer Cage
G. End Cap
H. Flow Control
I. Instruction Manual
Introduction
This Hozelock Cyprio Aquaforce pump is electrically
operated and is designed to pump solid particles
up to 10mm in diameter with minimal prestrainer
maintenance. These types of pumps are particularly
suitable for pumping water to external filters or for
use in high flow waterfalls or watercourse applications
where low maintenance is important. The pump does
not use oil or grease for lubrication and can be used
safely in ponds containing fish or plants. The motor
consists of a sealed stator and water-cooled rotor. All
electrical components are isolated from the water.
ATTENTION
AUTOMATIC CUT-OUT
To help ensure your pump's long life and to prevent
damage, it is fitted with automatic thermal overload
protection. This switches off the pump if it overheats.
If this occurs, switch off the power at the mains supply
to the pump. Check for the cause. Usually it will be
debris blocking the inlets of the pump or obstructing
the impeller. Remove the obstruction and wait for the
pump to cool down. Then switch on the pump again.
General Safety Guidelines
1. This pump has been designed for the use with
ponds only. Only use this pump for the operation
of pond filter systems, water displays, waterfalls
etc. Do not use this pump for any other use (i.e. do
not use this pump in swimming pools, bathrooms,
central heating systems etc). Using the product
for any other application may result in injury or
product damage.
2. Important - This appliance must only be used by
a responsible adult who is capable of using the
appliance in a safe way and who understands the
hazards involved. Use and store this appliance
out of reach of children and persons with reduced
physical, sensory, or mental capabilities.
3. WARNING: Always unplug or disconnect all
appliances in the pond from the electricity supply
before putting your hands in the water whilst
equipment is being installed, repaired, maintained
or handled. Never immerse the plugged end of
the cable in water.
4. Never use the mains supply cable to lift the pump,
as this may cause damage. We recommend fitting
a lifting cord to the handle on the strainer cage
when the pump is installed in deep water.
5. Do not operate or leave the pump in freezing
conditions.
6. Protect the pump from direct sunlight. Direct
sunlight may overheat the motor.
7. Never allow the pump to run dry.
8. Do not operate this pump without the strainer
cage properly attached. Using the pump without
the strainer cage may invalidate your guarantee.
9. ATTENTION: This product is not suitable for water
temperatures above 35ºC.
10. ATTENTION: Do not operate this product if the
mains supply cable or the motor has become
damaged in any way. The supply cable cannot
be replaced as it is permanently encased in the
motor housing and should therefore be disposed of
according to local regulations.
11. If you live in a hard water area (water with high
calcium or limescale content), the pump, rotor
assembly and inside of motor should be cleaned at
regular intervals (See MAINTENANCE).
12. Only use accessories which have been designed
for use with this product. The use of any other
accessories may invalidate your guarantee.
13. This pump is not suitable for use with salt or sea
water.
14. For the maximum total head of these pumps,
please refer to the table at the end of these
instructions.
5