Publicidad
Idiomas disponibles
Idiomas disponibles
indicating that the system is ready to accept programming for the unlock/
panic channel.
(If you desire one button to control lock & unlock, move on to step 9)
8. Press and hold the selected remaining choice a, b, or c above, until the
siren emits a long "chirp" to confirm that programming of unlock channel
was successful.
9. Press and release the valet push-button switch one time.
10. The dash mounted LED will flash 3 times, and the siren will "chirp"
indicating that the system is ready to accept programming for channel
2, or the pulsed ground output for remote trunk release, remote car
starter, etc.
11. Press and hold the selected remaining choice a, b, or c above, until the
siren emits a long "chirp" to confirm that programming of channel 2 was
successful.
12. Press and release the valet push-button switch one time.
13. The dash mounted LED will flash 4 times, and the siren will "chirp"
indicating that the system is ready to accept programming for channel
3, or the additional pulsed ground output if available on your model.
NOTE: If the program switch is operated again, the circuit will recycle
through the program mode. In other words, press 1 time to access the
lock function, 2 times to access the unlock function, 3 times to access
the start function. When programming is complete, simply turn off the
ignition switch to exit the program mode.
ERASING TRANSMITTERS IF THEY HAVE BEEN LOST OR STOLEN:
NOTE: Before you begin to erase the lost or stolen transmitter(s), have all
transmitters available that you wish to remain programmed. These
will be used during the program process to identify transmit-
ters that will continue to be used.
Enter the transmitter program mode:
1. Turn the ignition switch to the "ON" position.
2. Within 10 seconds, press and release the valet/program switch three
times. (Siren emits 1 short chirp indicating channel 1 has been
entered)
3. Within 10 Seconds, press and hold the ARM or ARM/DISARM but-
ton of the first transmitter you wish to remain stored into the
control unit until a single chirp is heard from the siren.
(Repeat this for each transmitter you wish to remain stored in the control
unit).
The receiver stores up to four transmitters. To be certain all transmitter
slots in the receiver are occupied with transmitters you wish to continue
to use, and all others are erased, you will have to fill all four receiver slots.
If in step 3 you identified one transmitter, you will have to fill the additional
3
128-6463
3 of 16
Publicidad
