Front Panel Features - Numark CDN35 Manual De Inicio Rápido Del Usuario

1. Make sure all items listed on the front of this guide are
included in the box.
2. READ SAFETY INSTRUCTION BOOKLET BEFORE
USING THE PRODUCT.
3. Study this setup diagram.
4. Mount the units in your console or rack with 19" EIA
rails.
5. The transport should be mounted not to exceed an
angle of 15 degrees.
6. Make sure all devices are turned off and all faders and
gain knobs are set to "zero"
7. Connect all devices as indicated in the diagram.
8. Connect the stereo outputs to power amplifier(s), tape
decks, and/or other audio sources.
9. Plug all devices into AC power.
1. Open/Close: Press to load or eject the disc. The tray will
not open if a disc is in play. The tray door will automatic
close in 30 seconds if left open. This is to protect the tray
from accidental damage while open.
2. Time: switches the time modes on the display between
elapsed playing time, remaining time on the track, and
remaining time on the total CD. When toggled to remaining
time total the total number of remaining tracks will also
show.
3. Single: toggles the unit to play back just one track at a
time (single) or play continuously through all tracks and
then start over repeating the CD infinitely (continuous).
4. LCD Display: Indicates all the functions, as they are
occurring, with the CD.
5. Track Buttons: These buttons are used to select the track
to be played.
6. Program: Depress this button and the unit will stop and
the program indicator will light. Select each track to be
programmed and press the PROGRAM button between
CD PLAYER QUICK SETUP
10.
11.
12.
More information about this product may be found at

FRONT PANEL FEATURES

selections. You can program up to 30 tracks. Press PLAY
to start the program. To exit and erase program, either
hold the program button down for more than 2 seconds
while the unit is stopped, open the disc tray, or turn off the
power.
7. Cue: Returns and pauses the music at the last set cue
point. The cue point is where the music will begin when
play is pressed. The cue point is set as the initial start
point on a track or can be moved when play is started at a
different point. For instance if the music is paused, then
play is pressed, a new cue point is set. You can easily edit
the cue point by turning the wheel during pause. As you
rotate the wheel the music will sound. By stopping the
wheel and pressing play, a new point is set.
pressing the PLAY button and the CUE button allows the CD
to be played from the same position any number of times.
Note: Pressing cue 2 times plays music temporarily from
this point until the button is released.
Switch everything on in the following order.
• audio input sources (i.e. turntables or CD
players)
• Mixers
• last, any amplifiers or output devices
When turning off, always reverse this operation by,
• turning off amplifiers
• Mixers
• last, any input devices
Go to http://www.numark.com
registration.
http://www.numark.com
for product
Alternately,