Sunny Health & Fitness SF-E905 Manual De Usuario página 15

ADJUSTMENTS & USAGE GUIDE
1. If you find there is no difference between tension level 1 to level 8, please check the
connection of the tension cable. Please see Diagram A under Step 2.
2. If the meter does not show numbers correctly, please check the batteries. If the meter
does not count the speed and time, please check the connections of Upper Sensor Wire
(No. 15) to the Meter (No. 38) and Upper Sensor Wire (No. 15) to Lower Sensor Wire
(No. 16).
3. If you have difficulty putting Hinge Bolts (No. 19L/R) into the Crank Arm (No. 49), please
try moving the Crank Arm (No. 49) to a different angle. *Keep in mind the Left Locking
Bolt (No. 19L) has reversed threading and must be installed by turning counter-clockwise.
4. If you hear any noise when using the machine, please check if Hinge Bolts (No. 19L/R),
Hex Bolts (No. 21), Flat Washers (No. 26) and Connecting Joints (No. 52) are loose.
You may remove these parts and add some lubricant oil to eliminate all noise possibilities.
Remember to tighten all the parts securely.
5. When you first use the machine, if you hear any unusual noises from the inside of the Belt
Cover (No. 65L/R), please loosen the screws on the belt cover about two rotations, then
push the Belt Cover (No. 65L/R) up a little bit. Finally, fasten the screws you loosened
before. See the following diagram. (During shipping, the Belt Cover (No. 65L/R) can be
dislocated, and the Flywheel (No. 94) may rub on the Belt Cover (No. 65L/R).
14