Intrusion Warning Signals - Panther PA-120C Manual Del Propietário

INTRUSION WARNING SIGNALS

This system will inform you if an intrusion attempt has occurred while you were away from the
vehicle. If an intrusion attempt has occurred, the Siren or Horn will chirp 4 times and the parking
lights will flash 3 times when disarming the system. Enter the vehicle, and observe the red dash
mounted LED to identify which zone was triggered.
If the LED is flashing one time...pause...one time...pause...etc., then the shock sensor was
activated in your absence.
If the LED is flashing two times...pause...two times...pause...etc., then an intrusion attempt was
made to a hood or trunk pin switch that was added to the system.
If the LED is flashing three times...pause...three times...pause...etc., then an intrusion attempt
was made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory, and will only be erased
when the ignition key is turned on.
Valet Mode:
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to
hand your transmitter to parking attendants or garage mechanics. When the system is in valet
mode, all alarm functions are bypassed, however the remote panic feature and remote door
locks will remain operational. To use the valet mode, the system must first be disarmed either
by using your keychain transmitter, or by operating the manual override sequence.
1. From the disarmed condition, turn the ignition key to the on position.
2. Press and hold the valet push-button switch until the dash mounted LED, (Light
Emitting Diode) turns on. The LED will remain on as long as the system is in valet
mode.
3. To return to normal operation, turn the ignition switch on, then.
press and hold the push button switch until the LED turns off.
NOTE: Always remember to return the system to the NON VALET mode, after servicing, to
ensure that the vehicle remains protected at all times.
MANUALLY OVERRIDING YOUR SYSTEM:
Using The Valet / Manual Override Switch:
Your Security System can be disarmed without the use of the keychain transmitter. This is
necessary, since you will need the ability to operate your vehicle if the transmitter is lost or its
battery fails.
To override the system:
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the on position.
3. Within 10 seconds, press and release the valet push button switch.
The alarm system will stop sounding and enter the disarmed mode. You can now start and
operate the vehicle normally.
Typically this override mode is used only if the transmitter has become inoperative. You may
elect to enter the VALET mode until repair or replacement of the transmitter, after which,
returning the system to the full operation mode is necessary. To do so, see the heading
VALET SWITCH.
ELIMINATING THE NORMAL ARM / DISARM CHIRPS
As explained earlier in the manual, you can eliminate the chirps selectively any time you arm or
disarm the system simply by pressing both the lock and unlock transmitter buttons. If you find
the normal arming and disarming chirps annoying, they can be turned off permanently, eliminat-
ing the need to press both buttons. To turn chirps off permanently, selectable features # 6 must
be turned off in the feature programming section of the installation manual. Refer to this manual
or consult with your installation technician to have this feature turned off.
Page 4
128-9111a
4 of 14