Panther PA-120C Manual Del Propietário página 6

Disarming The Hi-Jack Feature:
Anytime after the Hi-Jack mode has been triggered, the circuit can be disarmed simply by:
1) Turn the ignition switch from off to on
2) Within 10 seconds of 1, press and release the push-button override switch. Depressing
this switch one time will cause the security system to reset the Hi-Jack mode.
The circuit will not trigger again unless the door is opened and then closed while the vehicle
is running.
Car Locator:
Anytime during the armed mode, if the Lock button is pressed within range of the vehicle, the
Siren or Horn will chirp 6 times and the parking lights will flash 12 times allowing easy location
of the vehicle in a crowded parking light.
Transmitters Included With This Kit:
The transmitters are programmable and at times it may become necessary to replace trans-
mitters if they become broken or if they are stolen. If this is the case, order replacement
transmitters from Audiovox go to www.prestigecarsecurity.com. The transmitters pack-
aged with this kit are PA91.
To Program new or replacement transmitters:
1. Enter the vehicle, and turn the ignition key to the "on" position.
2. Press and release the valet/override/program push button switch 3 times.
3. The dash LED will flash one time and the Siren or Horn will "chirp" 1 time indicating the
system is ready to accept programming for channel 1Arm/Disarm, Lock/Unlock
and Panic.
4. Press and hold the lock button of the first transmitter until the parking lights flash and a long
chirp is heard from the Siren or Horn
Repeat for each transmitter to be programmed. Note a maximum of 4 transmitters can be
programmed.
Turn the ignition switch off or allow 15 seconds of inactivity to exit the transmitter program
mode.
By completing the above, all three buttons of the transmitters are programmed into their
default location.
Lock = Lock / Arm, & Panic
Unlock = Unlock / Disarm & Panic
Trunk = Trunk Release & Panic Cancel, Press & Hold 2.5 seconds to release
trunk, Press while Panic Sounding to cancel panic immediately.
Second Vehicle Operation:
Press the Trunk/Key button + the Option button for 2 seconds, theLED flashes 2 times.
Release the buttons, then press any transmitter to select 2nd vehicle mode.
While in the 2nd car mode, press the Trunk/Key button + Option button for 2 seconds, the
LED flashes 1 time to indicate the primary vehicle operation.
When in the second car mode, you can program the transmitter to a second vehicle which
may have a similar Panther Alarm system installed allowing full functional control of both
vehicles.
Battery Replacement:
Use CR2016 X 2 or equivalent.
1) Using a coin pry apart the case where indicated by
the arrow.
2) Carefully separate the top case from the bottom.
3) Carefully remove the discharged batteries from
under the clip.
4) Properly dispose of the discharged battery.
5) Replace with two new CR2016 batteries.
6) Carefully align and snap the transmitter case closed.
.
Page 6
128-9111a
6 of 14