Gear Drive; Torque Control / Drill Step; Preparing The Tool For Use; Changing The Direction Of Rotation / Unlocking The Device - Parkside PABS 10.8 A1 Instrucciones De Utilización Y De Seguridad

After you have inserted the required bit and fixed it
in place by turning the chuck
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch
©

2 Gear Drive

Note: Move the gear selector switch
after the device has come to a standstill.
In the first gear (Gear selector switch
in Position: 1)
you achieve a speed of approx. 400 rpm and a high
torque. This setting is suitable for all screwing tasks.
In the second gear (Gear selector switch
in Position: 2)
It achieves a speed of up to approx. 1300 rpm, for
the carrying out of drilling tasks.
©

Torque control / drill step

You can use the torque control / drill step
just the torque. When the value of the torque
setting is reached, the clutch disengages the drive
connection to the chuck.
Select a low setting for small screws, soft work
material.
Select a high setting for large screws, hard
work materials and for the extraction of screws.
For drilling work, select the drill setting by putting
the torque control / drill setting into the
For drilling tasks, also push the gear selector
switch to the front (Position: 2).
1
©

Preparing the tool for use

©
Changing the direction of
rotation / unlocking the device
Unlock the device and change the direction of rota-
tion by pressing the rotational direction switch
to the right or to the left.
Before first use / Preparing the tool for use
©
, you can immedi-
Switching on:
).
6
1 only
Switching off:
1
Changing the rotational speed:
The ON / OFF switch
control. Light pressure on the ON / OFF switch
causes the device to operate at a low speed. In-
creasing the pressure increases the speed.
1
©
11 to ad-
©
When screwing into wood, metal and
other materials:
position.
Torque:
Hard screw bed:
5

Switching ON / OFF

To start the appliance squeeze on the ON /
OFF switch and then keep it pressed down.
6
The light comes on with a slightly or fully
10
pressed ON / OFF switch
the working area in poor lighting conditions.
To stop the appliance, release the ON / OFF
switch 6 .
has a variable speed
6

Activating the lock

Press the rotational direction switch
middle position. The ON / OFF switch
now blocked.

Tips and Tricks

Screw bits are designated with their dimensions
and their shape. If you are unsure, always try
the particular screw bit out to see whether it sits
in the screw head without any free play.
Before you use the appliance, check to see
that the screw or drill bit is properly fitted, i.e.
located centrally in the chuck.
Smaller screws and bits in particular can be
easily damaged if you adjust the appliance
with too high a torque and/or rotation speed.
Particularly high torques can occur, for example
with metal screws tightened by socket tool bits.
Select a lower rotation speed.
and illuminates
6
6
into the
5
is
6
GB/MT 41