Kenwood DNX Serie Manual De Instalación página 4

Connection
Ignition key
switch
Car fuse box
Car fuse box
(Main fuse)
A
Battery
⁄
Connect to the vehicle's parking brake
detection switch harness.
Parking sensor wire (Light Green)
⁄
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matched to your car is
required.
Connect to the terminal that is grounded when either
⁄
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
⁄
If no connections are made, do not let the cable come out from the tab.
4
DNX SERIES
¤
If you connect the ignition wire (red) and the battery wire (yellow)
to the car chassis (ground), you may cause a short circuit, that in
turn may start a fire. Always connect those wires to the power
source running through the fuse box.
ACC
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) -
(To car chassis)
A
PRK SW
For best safety, be sure to connect the parking sensor.
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
the telephone rings or during conversation.
To connect the Kenwood navigation system,
consult your navigation manual.
Depending on what antenna you are using,
When using the optional power amplifier,
connect to its power control terminal.
To steering remote
To car light control switch
Antenna Cord
FM/AM antenna input