Operating The Shredder; If Something Does Not Work - Olympia PS 57 CC Plus Manual De Instrucciones

Operating the Shredder

The shredder works using an automatic shredding mechanism. The optical sensor for the materi-
al in the automatic insertion is positioned in the centre of the slot.
Caution! Risk of injury through sharp edges on the cutting mechanism. NEVER
take hold of the shredder by the underside when the shredder is in operation.
1
Set the switch to its Auto position. The shredder is now ready to operate.
Warning! Risk of injury through automatic insertion. The infeed starts automati-
cally when material is inserted. Keep all loose pieces of clothing, jewellery,
long hair or other loose items away from the shredder's insertion slot.
2
Feed the material to be shred in the centre of the insertion slot. The insertion slot draws
the material in and stops 2 - 4 seconds after shredding has been completed and no further
material is fed in.
3
If you want to shred a credit card, insert the credit card in the centre of the slot with a short
edge to the front.
Switching the Shredder Off
Switch the shredder off when you no longer need to use it. This saves electricity and prevents
third parties inadvertently injuring themselves with the shredder.
1
Set the switch to its Off position.
2
Disconnect the power plug from the power socket.
Transporting the Shredder
If you want to transport the shredder for use elsewhere, use the practical castors provided on the
underside of the shredder.
1
Ensure that the shredder is switched off and disconnected from the power supply.
2
Use the handles to raise the shredder slightly. The shredder is now standing on the castors
and can be simply pushed to the new location.

If Something Does Not Work

The following information should help if something does not work as you expect it to.
Overheating Protection
The motor switches off automatically in the event of overheating and overloading. When the cool
down phase has elapsed, the shredder is ready to operate again. Pay attention to the intermit-
tent operation value.
14
Attention! Risk of property damage through material jam! Observe the
maximum cutting output of the insertion slot.
G