Unpacking Instructions - Fanimation The inlet FPS7880 Serie Manual Del Propietário

This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• One ¼˝ blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 4). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 13)
Ceiling Bracket Assembly
Fan Motor Assembly
• One wire stripper
• Three wire connectors
(supplied)

Unpacking Instructions

Support Light Kit
Assembly
Lower Glass
Materials
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
ace should you be interrupted.
• Fan Motor Assembly
• Ceiling Bracket Assembly
• Support Light Kit Assembly
• 18W CFL Bulb
• Lower Glass
• Blade Set
• TR20WH Hand-held Remote
• Receiver Unit
TR20WH
Hand-held Remote
Blade Set
3
Wire Size A.W.G.
14
12
• Hardware bags:
– 3/16-24 x 11mm screws
with pan head (13)
– Steel washer
– Wire nuts (4)
– Phillips screwdriver, 4˝
– 3/16-24 x 13mm screws
with flat head (4)
CFL
Bulb
Receiver
Unit
Hardware Bags