Beem Soraya III Manual Del Usario página 26

EN
Operation
To allow the device to be supplied with power and be used, press the On / Off switch (12).
The operating lamp in the On / Off switch lights up.
Thermostat Control
The thermostat control (7) is used to switch the device on and off and set the temperature of
the water.
Switch on
Turn the thermostat control clockwise until it resists.
Switch off
Turn the thermostat control anticlockwise until it resists.
The heating control lamp (8) lights up as soon as the heating element of the device starts
heating the water. The heating control lamp lights up at intervals when the water is boiling at
intervals.
Removing / Attaching the Lid
1. Hold the lid (15) at the lid handles (4) and pull it upwards.
If the device has been in operation, use potholders or similar gloves as the lid might be
hot. Always allow the device to cool down before using it again.
2. To close the lid, place it on the water reservoir (6).
Filling the Water Reservoir
Only ever fi ll the water reservoir (6) with fresh, clear tap water. Do not pour in any other
liquids.
3. Take off the lid (15) (see the "Removing / Attaching the Lid").
4. Pour the desired quantity of water into the water reservoir. Note the MAX marking.
5. Close the lid (see the "Removing / Attaching the Lid").
Operating the Discharge Tap
1. Press down the lever (14) and keep it pressed down. The discharge tap (13) opens and
water fl ows out (Illustration A).
2. Let go of the lever when the quantity of water you want has been removed. The discharge
tap closes again.
28