Function copying
Configuration method
2. Point to the infrared emission window (usually
refers to the infrared device installed in the front
of your remote control) of the original remote
control to the infrared emission of your RM-090
window (separate 2 to 5 cm).
3. Press any button on the original remote control and release when the indicator LED lights
up and stays lit; instantly the information of the buttons will be copied to your RM-090.
4. Press the button corresponding to the equipment within your RM-18 control panel; now
the indicator LED will flash again and the transferred information will be saved in the key
chosen in your RM-090. According to your needs you can repeat steps 3-4 to set up the
remaining buttons on his control. When finished press the "SET" button to terminate the
learning function.
The learning function has a limited memory space, when this space is over, the LED indicator
will flash quickly 5 times to indicate that it is over.
If you need to delete information that has copied and transmitted previously to your RM-090,
press the "SET" button and simultaneously press the button of the device that you want to delete;
then enter the 9981 code while the LED indicator is on, so the information will be removed.
10
10
1. Press the device key that you want to your
RM-090 to copy. Press and hold the "LEARN"
button for three seconds to start the learning
function.