Kronos pH/ORP Serie Manual De Instalación página 7

Paragraph 3 – Proportional dosing for the Redox (O.R.P.) measurement
Programming
PROG
Config.
Config.
Funct.
Funct.
Redox
Setpoint
0mV
Set. Type
High
ProBand
100mV
AlarmBnd
20mV
OFA
0m
Calibr.
Probe
0000138014
The pump measures and controls the Redox value of a solution, by
programming
proportional band and alarm band.
Set-point type: maximum
s/m
max
flow-rate
0
Set-point type: minimum
s/m
max
flow-rate
0
Can also be programmed:
- The O.F.A. (Over Feed Alarm) time in minutes, a set period of time after
which, if the measured Redox value does not reach the set-point, an
alarm signal is activated.
- Activation / deactivation of the calibration procedure
Display during operation
Allarmi e stati
• Cal = calibrazione non
eseguita
• Liv = Allarme livello
• Fls = Allarme flusso
• Alm = Misura fuori •
Banda allarme •
• OFA = Allarme O.F.A.
•
the following
Pump Off
Alarm Band
Proportional
Band
Alarm Band
465mV Valore misura del
P 100%
potenziale Redox.
Valore del dosaggio in corso
(dipende dall'unità di misura
selezionata)
Stato della pompa
•
Vuoto = pompa in start
Stop = pompa ferma
Paus = pompa in pausa
rev. 1.0 EN
Operation
parameters: set-point,
Proportional
Band
Alarm Band
Pump Off
Alarm Band
Percentuale, Frequenza,
l/h, Gph, ml/m
set-point type,
mV
mV
5