Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MPTL144DD 3/8"
MPTL192DD 1/2"
IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER & BATTERY CARTRIDGE
1.
CAUTION: To reduce risk of injury, charge only
Matco rechargeable batteries. Other types of
batteries may burst causing personal injury
and damage.
2.
Before using
battery charger,
read all instructions
and cautionary
markings on
batteries and
chargers.
3.
Do not expose charger to rain or snow.
4.
To reduce the risk of damage to electric plug
and cord, pull by plug rather than cord when
disconnecting charger.
5.
Use of an attachment not recommended or
sold by the battery charger manufacturer
may result in a risk of fire, electric shock, or
injury to persons.
ADDITIONAL SAFETY RULES FOR CHARGER AND BATTERY CARTRIDGE
1.
Do not charge battery cartridge when
temperature is below 10˚C (50˚F) or above
40˚C (104˚F).
2.
Do not attempt to use a set-up transformer, an
engine generator or DC power receptacle.
3.
Do not allow anything to cover or clog the
charger vents.
4.
Always cover the battery terminals with the
battery cover when the battery cartridge is
not used.
5.
Do not short the battery cartridge:
Do not touch the terminals with any
conductive material.
Avoid storing battery cartridge in a container
with other metal objects such as nails, coins,
etc.
MPTL144DD/MPTL192DD
14.4V DRILL AND DRIVER WITH LED LIGHT
19.2V DRILL AND DRIVER WITH LED LIGHT
SYMBOLS
V . . . . . . . . . . . . . . . . . . . Volts
A . . . . . . . . . . . . . . . . Amperes
Hz . . . . . . . . . . . . . . . . . . Herts
W . . . . . . . . . . . . . . . . . . Watts
. . . .Alternating Current
. . . . . . . . Direct Current
6.
Make sure cord is located so it will not be
stepped on, tripped on, tripped over, or
otherwise subjected to damage or stress.
7.
Do not operate charger with damaged cord
or plug. Replace them immediately.
8.
Do not operate charger if it has received
a
sharp
blow,
otherwise damaged in any way. Return
tool to Tri-County Power Tool, Inc. or
Pneutool
Parts
for repair.
9.
To reduce the risk of electric shock, unplug
charger from outlet before attempting any
maintenance or cleaning. Turning off controls
will not reduce this risk.
10. Do not disassemble charger or battery
cartridge. Return tool to Tri-County Power
Tool, Inc. or Pneutool Parts & Services
Co. Ltd. when repair is required. Incorrect
reassembling may result in a risk of electric
shock or fire.
6.
Do not store the machine and battery
cartridge in locations where the temperature
may reach or exceed 50˚C (122˚F).
7.
Do not incinerate the battery cartridge even
if it is severely damaged or completely worn
out. The battery cartridge can explode in a
fire.
8.
Be careful not to drop, shake or strike the
battery.
9.
Do not charge inside a box or container of
any kind. The battery must be placed in a
well ventilated area during charging.
2
been
dropped,
&
Services
Co.
Ltd.
08/30/06
or
Publicidad
Tabla de contenido
