Metra 108-FD5CH Instrucciones De Instalación página 4

7. Unclip the shifter trim bezel and slightly
pull it up to clear the center console trim
bezel removal.
8. Open the center console storage
compartment. Unclip the center console
trim bezel, then slide it toward the rear
of the vehicle to remove it. (Figure G)
Note: The complete center console
does not need to be removed. but if it is
desired to be removed, the Push-to-
Start module must be connected when
testing the kit.
9. Remove the plastic tray in front
of the shifter.
10. Remove the center plastic trim
(knockout) between the power outlet
and USB jack. (Figure H)
4
DASH DISASSEMBLY
(Figure G)
(Figure H)
(CONT.)
Ensure that the vehicle is completely off before
proceeding onto the following (4) steps:
11. Remove the (4) 9/32" screws securing
the radio/climate control panel, and then
unclip, unplug, and remove. (Figure I)
12. Remove the (4) 9/32" screws securing the
display screen, then unplug and remove.
(Figure J)
13. Remove the (4) 9/32" screws securing the
radio chassis, then unplug and remove.
(Figure J)
14. If the vehicle is equipped with SYNC,
remove the (3) 9/32" screws securing the
SYNC® module, then unplug and remove.
Continue to Kit Preparation
(Figure I)
(Figure J)
|
386.257.1187 MetraOnline.com