Installation - Metra 108-FD5CH Instrucciones De Instalación

It is highly advisable to read the following steps beforehand, to ensure a clear understanding of
what is to be expected. The following steps must be done in the order that they are numbered.
With the vehicle completely off:
Touchscreen display
1. Connect the 16-pin harness with stripped leads into port "B" in the touchscreen display.
2. Connect the main harness to the wiring harnesses in the vehicle. These harnesses are the
ones removed in step 13 of dash disassembly. Then insert the main harness into port "A"
in the touchscreen display. But do not install this harness until exactly before step 1 of the
Programming section. This is a timed process.
3. Connect the 4-pin harness with yellow RCA jacks into port "C" in the touchscreen display.
4. Disregard ports "D" and "E", they will not be used in this application.
5. Port "F" is an update port for future firmware upgrades.
A
F
Note: DO NOT CONNECT!
12
B
C
D
E

INSTALLATION

HVAC interface
6. Connect the HVAC interface harness into the HVAC interface, and then to the wiring
harnesses in the vehicle. These harnesses are the ones removed in step 11
of dash disassembly.
a. Then connect the 10-pin harness into the engine start/stop circuit board assembly.
Attention! There are (2) 10-pin connectors, one in the engine start/stop circuit board assembly,
and one in the touchscreen display. Use only the appropriate connector and disregard the other
one. If the incorrect port is accidentally used, the vehicle will need to be reset by removing the
battery for a couple minutes.
Note: Disregard the 4-pin flat to 4-pin stacked harness, it will not be used in this application.
7. Connect the 6-pin harness from the main harness to the HVAC interface.
8. Connect the 12-pin backup camera harness, to the wiring harness in the vehicle. This
harness is the one removed in step 12 of dash disassembly.
9. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Use the antenna adapter provided to adapt the factory antenna connector to the
aftermarket radio.
Continued on the next page
|
386.257.1187 MetraOnline.com