DAB e.sylink Instrucciones De Instalación página 13

Input wiring
Input connected to clean contact
Input Clean contact between pins
I1 I1-VS
I2 I2-VS
I3 I3-VS
I4 I4-VS
Table 2: Input wiring
An input mode is described in Figure 1, just as an example (Connec-
tion to Input 1)
Figure 2: Example of wiring of input I1, input with clean contact
Voltage input
Jumper Connection
CB - GND I1 - CB
CB - GND I2 - CB
CC - GND I3 - CC
CC - GND I4 - CC
Output contacts:
The connections of the outputs listed below refer to the 9-pole terminal
board (J15), indicated with screen printing O1, O2 and CA.
Table 3 describes the characteristics and limits of the output contacts.
Characteristics of the output contacts
Type of contact
Max. bearable voltage [V]
Max. bearable current [A]
Max. accepted cable section [mm²]
Table 3: Characteristics of the output contacts
An example of connection on the output contacts is shown below in Figure 2.
Figure 3: Example of output connection
GB
ENGLISH
NO (Normally open)
24
5 -> resistive load
2,5 -> inductive load
2,5
13