Heath Zenith 7162 Manual De Instrucciones página 5

Determining the Motion Sensor Detection Zone
The motion sensor is non-adjustable. It has a sensing angle of 180°
and a range of approximately 40 ft. depending on the surrounding
temperature. When the control dial is set to the "TEST" position, the
light will operate during the day or night. The light will stay on for 5
seconds after all motion is stopped. The motion sensor will need to
completely warm up (60 seconds) before beginning the setup process.
1. Turn the control dial to the TEST position (see Figure 9).
2. Perform a "walk test": walk in an arc across the front of the mo-
tion sensor (see Figure 10).
3. Watch the light. The light will come on indicating motion has
been detected.
4. Stop, wait for the light to turn off, and then begin walking again.
5. Continue this process until the detection zone has been established.
6. If needed, gently grasp the lamp heads and move them from side
to side or up and down to adjust the light coverage area.
Adjusting the Light Timer
Turn the control dial to set the amount of time you want the lights
to stay on after all motion has stopped (adjustble between 5 seconds
and 5 minutes) (see Figure 11). Note: When set between 5 seconds
and 5 minutes, the light fixture will only work after dark (sunset).
Using the OFF Control
Turn the control dial to the OFF position to turn the light off and
to conserve the battery life (see Figure 12).
208824-02
OPERATION
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Figure 8
W
Figure 9
Figure 10
W
Figure 11
W
Figure 12
5