Kenmore 41781912510 Instrucciones De Instalación página 8

Installation Instructions
Electrical connection (non-Canada) - 4 wire cord
4-wire receptacle
(NEMA type 14-30R)
30 AMP 30 AMP
NEMA 14-30 NEMA 14-30
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing could
result in personal injury or even death.
1 Turn off power supply to outlet.
2 Remove the three screws securing the terminal block
access cover in the upper corner on the back of the
dryer.
3 Disconnect the internal (WHITE) dryer harness ground
wire from the (GREEN) ground screw next to the
terminal block.
4 Using an UNPLUGGED, UL-approved, 30 amp. power
cord, NEMA 14-30 type ST or SRDT, attach the
ground (GREEN) power cord wire to the cabinet with
the ground (GREEN) screw. Tighten the screw securely.
NOTE
Terminal screws were shipped from the factory temporarily
attached inside the access cover.
5 Move the internal dryer harness ground (WHITE) wire
to the terminal block and attach it along with the
neutral (WHITE) power cord wire conductor to the
center, SILVER colored terminal on the terminal block.
Tighten the screw securely.
6 Attach the RED and BLACK power cord conductors
to the outer, BRASS colored terminals on the terminal
block. Tighten both screws securely.
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/conductor at
connections.
7 Reinstall the terminal block cover.
WARNING
ELECTRICAL SHOCK HAZARD
Do not operate dryer without terminal cover in place.
A correctly installed terminal block cover also acts a
qualifi ed strain relief for the power cord.
Neutral Neutral
(WHITE wire) (WHITE wire)
Ground Ground
(GREEN wire) (GREEN wire)
BLACK
or RED
power wire
WHITE
neutral wire
GREEN
ground wire
8
terminal cover
access cover
screw
DO NOT
REMOVE THIS
SCREW
access cover
screw
access cover
screw
line 1 - L1
(BRASS terminal)
neutral - N
(SILVER terminal)
line 2 - L2
(BRASS terminal)
move internal
ground wire to the
center terminal for
4-wire system
route cord here
neutral
terminal
GREEN
ground screw
BLACK
or RED
power wire