Making A Cut - Battipav Super Pro Evo Manual De Instrucciones

GB
Tool:
TUNGSTEN CARBIDE WHEEL
Art. 492
Intended use:
CERAMICS, SINGLE-FIRED TILES, GRES,
KLINKER, TERRACOTTA AND MARBLE
USE
CAUTION
All our tools undergo a series of tests and are
carefully checked before they leave our factory.
BATTIPAV is constantly involved in developing the
equipment we supply. We therefore reserve the
right to make any changes we deem necessary. No
demands may therefore be made on the basis of the
information and illustrations found in this manual.
The SUPER PRO EVO tile cutter is a tool that is
technologically advanced and that offers high
performance. It is suitable for cutting ceramic
materials.
WARNING
The manufacturer accepts no responsibility for
SUPER PRO EVO tile cutters used with other tools, or
for cutting any materials other than those indicated
in the "INTENDED USE" paragraph.
ASSEMBLY
Remove the machine from the packaging and
1
ensure that no component has been damaged.
Proceed by assembling the SUPER PRO EVO tile
cutter according to the type of use you wish to
implement.
a) Set up the carriage rod unit onto the
2
worktop.
3
Block the carriage rod unit into place with the
four screws supplied, ensuring that the cutting
4
wheel remains in the centre of the cutting side,
along its entire length.
5 Loosen the bracket fixing knob and move it from
the transport position to the working position.
6 Position the cutter beam bracket and lock it into
place using the fastening knob.
TRANSPORT
7
The SUPER PRO EVO tile cutter can easily be
transported.

MAKING A CUT

CAUTION
8
• Position the tile to be cut on the resting surface
at the cut point required.
9
a) Rest the tile on the worktable, with the cutting
point aligned. Position the carriage and set up
the cutting wheel using the side levers.
b) Proceed to cut the glaze by pushing on the
movement rod and exerting a constant
downward pressure for the entire length of the
tile.
10
c) Position the breaking foot using the side levers
on the carriage.
d) Then exert a gradually increasing pressure
until the tile is separated.
Use the graduated rods and the adjustable square
for repetitive cuts and / or specific cutting angles.
CAUTION
WHEN WORKING WITH HARD TILES, IT IS
ADVISABLE TO PRESS THE BREAKING FOOT
AGAINST ONE END OF THE TILE UNTIL IT STARTS
TO SEPARATE. COMPLETE THE BREAK BY
PRESSING ON THE OTHER END.
For greater precision, help yourself with the
11
cutting index and the relative tile support plate;
12
• For measurements less than 10 cm use the
LOWER index.
13 • For measurements greater than 10 cm use the
UPPER index.
12
Battipav srl