Pre-Start Check List; Lighting Instructions; Lighting The Main Burners - Signateur 1500111 Instrucciones De Montaje Y Cuidado

Tabla de contenido

Idiomas disponibles

Property damage, bodily harm, severe burns, and death could result from failure to follow these safety steps. These steps

should be performed after the grill has been assembled and prior to each use. DO NOT operate this grill until you have read

and understand ALL of the warnings and instructions in this manual.

• Ensure that the grill is properly assembled.

• Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. If it is evident there is excessive abrasion

or wear, or the hose is cut, it must be replaced prior to the grill being used. Replace with hose and regulator Model No. 1500111-0003,

which can be obtained by contacting Customer Service Call: 1-866-305-4414 (English only) Mon-Fri 6AM to 2PM PST or send us

email at support@signateur.com

• Properly place the empty grease cup under the grease drain hole in the bottom of the grill to catch grease during use.

• DO NOT block ventilation areas in sides, back or cart compartment of grill.

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and

instructions contained in the preceding sections of this manual.

Follow the instructions exactly.

1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion

could occur if grill lid is down.

2. Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.

3. Turn on the fuel supply by slowly rotating the cylinder valve knob counter-clockwise to full open.

4. DO NOT stand with head, body, or arms over the grill when lighting.

LIGHTING THE MAIN BURNERS:

1. Open lid before lighting burner.

2. Make sure all control knobs are in the "OFF" position.

3. Select the burner to be lit. Push and turn the control knob of that burner to the

High position.

4. Press the electronic igniter and hold for 3-5 seconds to light burner.

5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait

5 minutes to allow gas to dissipate and repeat lighting procedure.

6. Repeat steps 3-5 for lighting each burner. Always use electronic igniter for

lighting each burner. If burner does not ignite using the push-button igniter, see

Match Lighting the Main Burners section.

7. To turn off, turn each control knob clockwise until it locks in the OFF position.

This does not turn off the gas flow from the cylinder.

Note: If burner does not light or flame is too low, See "Trouble Shooting" section

of the owners manual.