Publicidad
This product must be installed professionally and in
accordance with the prescribed assembly guidelines. It
must only be assembled by qualified and trained experts!
Intended use
Heat meters are for the centralized recording of the consumption of heat
energy or cooling energy. Depending on their design, they are for measur-
ing hot water or hot water with glycol additives. Heat meters must be used
exclusively for this purpose.
Improper use
Any use other than the use described previously and any changes made
to the device constitute improper use. Uses and changes must be queried
in writing beforehand and are subject to special approval.
The installed meter is a pressurized component. There is a risk of persons
suffering scalds from hot water.
Warranty and guarantee
Warranty and guarantee claims are only valid if the parts in question have
been used in accordance with their intended use and if the technical
requirements and any applicable technical regulations have been
observed.
Safety notes
Improper handling and excessively forceful tightening of screwed connec-
tions can cause leaks. Observe the maximum torque stated in the manual.
The dimensions and thermal loads of seals must be appropriate for their
application. You should therefore only use the seals delivered with the
device.
Meters for heating water with glycol additives may only be used with the
glycol additive specified on the device.
Safety notes for lithium batteries
Various QUNDIS devices are equipped with lithium batteries. This type of
battery is classified as hazardous.
VALID TRANSPORT REGULATIONS ARE TO BE ADHERED TO IN
Inspection documents for the batteries used are available on request.
Handling of lithium batteries
•store protected from dampness
and moisture
•do not heat to above 100°C or
throw in fire
3
EACH CASE!
•do not short-circuit
•do not open or damage
•do not charge
•do not store within reach of
children
Publicidad
