Honeywell QUIETSET HS-1650 Serie El Manual Del Propietario página 2

17. Do not operate any fan with a damaged
cord or plug. Discard any damaged fan,
return the fan to the retailer where the
fan was purchased, or request a return
authorization to return to Kaz, Inc. for
examination and/or repair.
18. Do not run fan cord under carpeting. Do
not cover cord with throw rugs, runners,
or similar coverings. Do not route cord
FUSED SAFETY PLUG - FOR US MODELS ONLY
This fan features a fused safety plug which is designed to cut off electric current to the fan if an
electrical fault occurs. Please see below for more information on how to properly use your fan and
replace the safety plug fuse, if needed.
USER SERVICING INSTRUCTIONS
1. Grasp plug and remove from the receptacle or other outlet device. Do
not unplug by pulling on cord.
2. If your fan loses power and you suspect that the fuse on your fan has
blown, you should first remove the spare fuse holder attached to the
cord plug (Fig. 1). Remove the spare fuse from the plastic spare fuse
holder, and set the spare fuse aside (Fig. 2).
3. You can gain access to the blown fuse by sliding open the door found
on the side of the plug. Slide the door outward until the blown fuse is
fully visible (Fig. 3).
4. Carefully remove the blown fuse and snap the replacement fuse into
place. Risk of fire. Replace fuse only with 2.5 Amp, 125 volt fuse
(provided with product). Fully close the fuse door by sliding back into
place. Discard the blown fuse. The plug should now be ready for
normal use.
5. Risk of fire. Do not replace attachment plug. Contains a safety
device (fuse) that should not be removed. Discard product if the
attachement plug is damaged.
6. If you need further information on how or when to replace the fuse in
the safety plug, please contact Kaz Consumer Relations Department by
visiting our website at www.kaz.com or calling 1-800-477-0457.
2
under furniture or appliances. Arrange
cord away from traffic areas and where it
will not be tripped over.
WARNING:
To Reduce The Risk of Fire
or Electric Shock, Do Not Use This Fan With
Any Solid State Speed Conrol Device
Fig. 1
Fig. 2
Fig. 3