Rear View; Using The Am/Fm Radio; Air Compressor - Wagan Tech Power Dome EX Manual De Usuario

Power Dome EX by Wagan Tech
™

Rear View

Radio Tuning Dial
USB Power Port
Light (on side)
Radio Power Switch/
Volumn Control
AM-FM Selector
Audio Input Jack
AM/FM Radio
The Radio can receive frequencies in the standard AM and FM broadcast bands: AM 520
to 1710 kHz; FM 88 to 108 MHz. An extendable rod antenna provides adequate signal to
receive all local radio stations. When not in use, the antenna should be stored in its parking
location. This will prevent damage to the antenna while Power Dome is being moved. All Radio
controls are conveniently located in one area. The controls are: Radio Power Switch/Volume
Control, AM/FM Selection Switch, a Tuning Dial, and an Audio Input Jack for external audio
devices such as MP3s or CD players (Requires 3.5 mm mini audio cable-not included).
A USB Power Port is to the right of the Audio Output Jack can power/charge devices that
require 5 Volts at up to 500 mA through the use of a user-supplied cord.
To save energy, first raise and extend the antenna and select the AM or FM band before
turning on the radio.
NOTE: All AM band radios are subject to receiving noise interference from electronic devices,
static lightning strikes and some motorized equipment. If you are operating the Power Dome
inverter and noise is being received on the AM band, turn off the inverter or change the radio
to receive the FM band.
www.wagan.com
5

Using the AM/FM Radio

1. Carefully raise and extend the multi-section antenna.
2. Select either AM or FM band.
Antenna
3. Turn on the radio by turning the Radio Power Switch/Volumn Control knob clockwise.
4. Rotate the tuning dial to the desired frequency.
Jumper Safety Switch
5. Adjust the volume control to desired loudness.
Compressor Gauge 6. Adjust the position of the antenna for best reception.
7. After use, turn off the Radio by rotating the power/volume knob counterclockwise until
8. Carefully retract the antenna and return it to the parked position.
Compressor
Power Switch

Air Compressor

The Air Compressor can inflate a variety of tires and inflatable equipment. It can provide
inflation pressure up to 260 PSI (pounds per square inch). Be careful not to over inflate. Monitor
the compressor gauge while inflating. The compressor's power switch is located above the
compressor hose compartment.
Air Hose Compartment
Using the Air Compressor
CAUTION: Never connect or disconnect the nozzle with the compressor operating.
1. Before any tire inflation, look for the recommended inflation pressure information on
2. Open the compartment door at the rear of the Power Dome and extend the air hose.
3. Position the Power Dome so that you can see the pressure gauge.
4. Make sure the chuck lever is positioned up (away from the chuck opening).
User's Manual—Read before using this equipment
the knob clicks.
Compressor Hose Compartment
the sidewall of the tire.
©2010 Wagan Corporation
All Rights Reserved
Wagan and wagan.com are trademarks used by Wagan Corporation
6