Dc Power Port - Wagan Tech Power Dome EX Manual De Usuario

Power Dome EX by Wagan Tech
™
Charging the Power Dome
AC Charging
Make sure the supplied AC Charging Adapter is to be powered by the correct voltage. (i.e.
110V AC or 220V AC). Only use the AC charging adapter supplied with this unit.
1. Make sure all Power Dome switches are set to off.
2. Open the dust cover on the Charging Jack.
3. Connect the AC Charging Adapter to the AC outlet.
4. Plug the Charging Adapter's cord into the Power Dome's Charging Jack.
5. The Charging Indicator will light during the charging process.
6. Initial AC charge can take up to 34 hours.
7. Do not charge for more than 48 hours.
8. After charging the battery, disconnect the adapter from the AC outlet first, then from
the charging jack.
9. Replace the dust cover on the charging jack.
DC Charging in Your Vehicle or Boat
Only use the DC charging adapter supplied with this unit.
1. Note that the engine must be operating while charging Power Dome.
2. Make sure all Power Dome switches are set to off.
3. Open the dust cover on the Charging Jack.
4. Plug the Charging Adapter's cord into the Power Dome's Charging Jack.
5. Plug the DC Charging Adapter into an accessory outlet (cigarette lighter).
6. The Charging Indicator will light during the charging process.
7. Do not charge more than 16 hours using the DC method.
8. After charging the battery, disconnect the adapter from the accessory socket first, then
from the charging jack.
9. Replace the dust cover on the charging jack.
DC to AC Power Inverter
The Power Dome's inverter can operate most AC appliances or a combination of appliances
up to 400 watts. Operating time is dependant on the AC load (watts) and the charge and
condition of Power Dome's internal battery. Reduced AC loads and full charge on the battery
will result in longer operating time. Be sure to turn off or disconnect any AC appliance not in
use. There is a user replaceable 40 amp automotive type fuse below the Inverter Power Switch.
This fuse protects the inverter from an unlikely excessive input current. Ordinary overloads will
cause the inverter to automatically shut down. Reduce the load and restart the inverter.
www.wagan.com
3
User's Manual—Read before using this equipment
Using the Power Inverter
1. Open the AC outlet dust cover.
2. Connect the AC appliance or appliances to either AC outlet.
3. Turn the Inverter on by flipping the switch to the "||" position.
4. If the Inverter Power Indicator light is green, the inverter is operating.
5. Turn on one AC appliance and observe the Power Indicator.
• If the LED remains green, then turn on the second appliance.
• If the Power Indicator remains green, then both appliances are
operating properly.
• After use, remove the appliance plug and close the dust cover.
• If the Power indicator LED is not lit, then reduce the AC load.
If the inverter is still not operating, refer to the troubleshooting
table at the end of this User's Manual.
• Recharge Power Dome as soon as convenient.
Note:
• "|" = Turns on USB ports and DC outlets
• "O" = Off
• "||" = Turns on AC Inverter, USB ports, and DC outlets
CAUTION
Some rechargeable devices are equipped with a separate AC charger. These devices are
likely to operate properly with this inverter. Rechargeable devices that have built-in chargers
(see device owner's manual) may not operate properly with this type of inverter.
Some motorized devices may operate at excessively elevated temperature when used with this
inverter. During first use with this inverter, check for excessive motor temperature. Abnormally
elevated temperature of the device is an indication that they should not be used together.

DC Power Port

DC Power Port (accessory socket) is located to the left of the Battery Status meter (voltmeter).
The port can power a DC load up to 11 Amps. Overloading the port will result in tripping (a
self-resetting circuit breaker). Removing the overload automatically
restores power to the DC Power Port.
• Uncover the dust cover from the Power Port.
• Insert the 12V DC accessory plug into the Power Port.
• Operate the appliance as usual.
• After use, disconnect the accessory plug from the Power Port and store the accessory.
• Replace the Power Port's dust cover.
• Recharge the Power Dome as soon as convenient.
©2010 Wagan Corporation
Wagan and wagan.com are trademarks used by Wagan Corporation
All Rights Reserved
4