Mopar K6861577 Manual De Instrucciones página 3

DODGE DART FENDER BADGE INSTRUCTIONS
1. DEFECT REMOVAL : Remove any dirt nibs or defects in the paint that would result in objectionable read-through defects after
the badges are applied.
2. BODY SURFACE: Body surface temperature must be a minimum of 70°F during badge application to ensure conformability and
initial adhesive bond.
3. ALCOHOL WIPE: Wipe the body surface to which the badges will be applied with a clean, lint-free cloth moistened with isopropyl
alcohol to remove contaminants.
4. DRY WIPE: Wipe the same body surfaces as in step 3 with a clean, dry lint-free cloth to remove remaining haze.
Apply in a dust-free environment.
INSTALL RH FENDER BADGE
5. RH FENDER BADGE POSITIONING: First, measure down 25mm from the front fender feature line and place a piece of masking
tape there. Next, measure 25mm from the front edge of the door opening and place a piece of masking tape there.
6. RH FENDER BADGE LINER REMOVAL: Lay badge liner side up on flat, clean surface. Slowly remove liner in a 180° direction,
keeping part as flat as possible. Avoid finger contact with badge adhesive surface.
7. ADHERING RH FENDER BADGE: Hold the RH Badge part by the handling tabs and position upper edge of badge at the
top piece of masking tape. Do not allow the adhesive surface to become contaminated by touching clothing, floor, etc.
Align left edge of badge with the other piece of masking tape and lightly press badge to vehicle surface.
8. SQUEEGEE: Squeegee entire badge with a plastic squeegee. Start at the center and fan out to the edges using firm, overlapping
strokes.
9. PREMASK REMOVAL: Slowly remove the premask in a 180° direction, (flat to surface). Do not snap it off or remove in a 90°
direction, (perpendicular to the surface).
10. POST APPLICATION: Allow the vehicle to remain 70°F for at least fifteen minutes before taking outside in freezing conditions.
Do not power wash badge area for 72 hours.
11. REPEAT ON OTHER SIDE OF THE VEHICLE.
Page 3 of 3