Napa 791-7110 Instrucciones De Operación

This operaTing manual conTains
imporTanT safeTy informaTion.
read carefully and undersTand all
informaTion before operaTing Tool.
save This manual for fuTure use.
owner/user responsibiliTy
The owner and/or user must have an understanding of
the manufacturer's
warnings before using this hydraulic clutch jack.
Personnel involved in the use and operation
of equipment shall be careful, competent, trained, and
qualified in the safe operation of the equipment and
its proper use when servicing motor vehicles and their
components. Warning information should be emphasized
and understood.
If the operator is not fluent in English, the manufacturer's
instructions and warnings shall be read to and discussed
with the operator in the operator's native language by the
purchaser/owner, making sure that the operator
comprehends its contents.
Owner and/or user must study and maintain for future
reference the manufacturer's instructions. Owner and/or
user is responsible for keeping all warning labels and
instruction manuals legible and intact. Replacement labels
and literature are available from the manufacturer.
for your safeTy and To prevenT inJury:
use service Jack for
lifting purposes
always support
vehicle with
jack stands.
791-7110
operating instructions
only.
HYDRAULIC CLUTCH JACK
model# 791-7110
producT descripTion
and
The jack is designed for clutch/flywheel removal and
installation. Intended use: to remove, install and
transport (in lowest position) both 14" and 15-1/2"
clutches and flywheels. The two most common spline
sizes, 1-3/4" and 2" diameter, are included with this
product. The head plate enables clutch to be positioned
in either horizontal position for clearing underneath
vehicle or vertical position for installation and removal.
The spline sleeve rotates 360 degrees, turns side to side
and vertically tilts for precise clutch alignment.
DO NOT USE FOR ANY PURPOSE OTHER THAN THOSE
USES OUTLINED ABOVE !
THIS IS A LIFTING DEVICE ONLY. IMMEDIATELY AFTER LIFTING, SUPPORT THE
VEHICLE WITH APPROPRIATE MEANS.
DO NOT OVERLOAD. OVERLOADING CAN CAUSE DAMAGE TO OR FAILURE
OF THE JACK.
LIFT ONLY ON AREAS OF THE VEHICLE AS SPECIFIED BY THE VEHICLE
MANUFACTURER.
CENTER LOAD ON AREAS OF THE VEHICLE AS SPECIFIED BY THE VEHICLE
MANUFACTURER.
THIS JACK IS DESIGNED FOR USE ONLY ON HARD, LEVEL SURFACES CAPABLE
OF SUSTAINING THE LOAD. USE ON OTHER THAN HARD, LEVEL SURFACES
CAN RESULT IN JACK INSTABILITY AND POSSIBLE LOSS OF LOAD.
NO ALTERATIONS TO THE JACK SHALL BE MADE.
DO NOT WIRE, CLAMP OR OTHERWISE CAUSE THE HAND OPERATED LIFT
CONTROL VALVE TO BE OPERATED BY REMOTE MEANS.
READ, STUDY AND UNDERSTAND THE INSTRUCTION MANUAL PACKED
WITH THIS JACK BEFORE OPERATING. FAILURE TO HEED THESE WARNINGS
MAY RESULT IN LOSS OF LOAD, DAMAGE TO THE JACK, AND/OR FAILURE
RESULTING IN PROPERTY DAMAGE, PERSONAL OR FATAL INJURY.
1 05/31/07