Heath Zenith DualBrite 5597 Manual De Instrucciones página 3

Wire the Light Control
WARNING: Turn power off at circuit breaker
or fuse.
1. Remove the existing light fixture.
2. Install the mounting strap as shown using two screws
that fit your junction box.
3. The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
the cover plate. The small end then goes into one
of the slots on the mounting strap.
4. Route the light control's wires through the large
gasket holes.
5. Twist the junction box wires and fixture wires together
as shown. Secure with wire connectors.
Mounting
Black to
Strap
Black
Gasket
Junction box ground wire to
green ground screw on fixture.
204058-01
White to
White
Rubber
Plug
Mounting
Bolt
Mount the Light Control
1. Place the mounting bolt through the front of the
junction box cover. Push the small gasket hole over
the mounting screw.
2. Make sure the wire connectors and wires are inside
the junction box. Align the mounting screw with the
center hole in the mounting strap. Secure the fixture
to the mounting strap.
3. Push the rubber plug firmly into place.
4. If a wet location junction box was not used, caulk
the wall plate mounting surface with silicone weather
sealant.
Lamp Shade
Lock Nuts
Keep lamps at least 2" (51 mm) from the
sensor and 2" (51 mm) from combustibles.
CAUTION: To avoid water damage and electrical
shock, keep lamp holders 30° below horizontal.
5. Adjust the lamp holders by loosening the lock nuts,
but do not rotate the lamp holders more than 180°
from the factory setting.
6. Adjust lamp shades by loosening the screws several
turns, turn shades counterclockwise and remove.
Reinstall the shades in the desired position and
tighten screws.
Screw
3
Screw