Descargar Imprimir esta página

Safety Instruction - HIKVISION DS-HD1 Guia De Inicio Rapido

Publicidad

Idiomas disponibles

Idiomas disponibles

limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
thethe interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Please take attention that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
This product meets the applicable Industry Canada technical specifications.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may operate only using an antenna of a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and operated with minimum distance of 20 cm between the radiator and your body.
The user manual for local area network devices shall contain instructions related to the restrictions mentioned in the above sections, namely that:
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile
satellite systems;
(ii) the maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall comply with the e.i.r.p. limit; and
(iii) the maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the e.i.r.p. limits specified for point-to-point and
non point-to-point operation as appropriate.
Users should also be advised that high-power radars are allocated as primary users (i.e., priority users) of the bands 5250-5350 MHz and 5650-5850
MHz and that these radars could cause interference and/or damage to LE-LAN devices.
Product tested by UL to meet U.S. and Canadian Standards.
The power supply must conform to LPS. The recommended adaptor models
and manufacturers are shown on the right. Use the attached adapter, and do
not change the adaptor randomly.

Safety Instruction

CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instruction.
For more information, please visit https://us.hikvision.com/en.
Need help? Please visit "https://us.hikvision.com/en" for our local contact details.
SAVE THIS MANUAL FOR FUTURE REFERENCE
Model
MKAC-57-242500M, MKAC-57-242200M, MKAC-57-241500M
Manufacturer
MACABLE

Publicidad

loading