Using The Product; Assembling The Juice Extractor; Dismantling The Juice Extractor; Using The Juice Extractor - Cuisinart CJE500E Instrucciones

3. USING THE PRODUCT

A. ASSEMBLING THE JUICE EXTRACTOR
1. Place the juice extractor housing base on a level surface.
2. Make sure the safety bar is placed horizontally to the housing
base, that is, in an unlocked position.
3. Place the filter housing on the housing base.
4. Firmly lock the filter to the middle of the filter housing ensuring
that it is securely in place.
CAUTION: Careful not to touch the blades at the bottom of the
filter.
5. Put the lid on the filter housing by aligning the feed tube with
the filter.
6. Put the safety bar in the locked position by pulling the bar
onto the lid. Pull the bar back until it clicks into place.
7. Slide the pusher into the feed tube by aligning the slot of the
pusher into the recess located inside the feed tube.
8. Put the pulp container in place at the back of the juice extractor
by slightly tilting its opening to slide it under the lid.
9. Place the juice pitcher under the flow spout at the front of the
juice extractor with the handle facing the front.
12
10. Make sure that the pour spout is properly open. Never press
fruit when the pour spout is closed.
B. DISMANTLING THE JUICE EXTRACTOR
1. Turn off and unplug the juice extractor.
2. Remove the pusher from the feed tube.
3. Remove the pulp container from the juice extractor.
4. Lower the security bar into the unlocked position.
5. Lift and remove the lid from the filter housing.
6. Gently remove the filter housing without removing the filter.
You will only be able to remove the filter once the housing has
been removed.
CAUTION: Do not touch the blades at the bottom of the filter.
7. Make sure the flow spout is in the closed position. Remove the
juice pitcher.
C. USING THE JUICE EXTRACTOR
1. Make sure that the juice extractor is properly assembled. (See
instructions section 3A).
2. Plug the unit into a 230V mains socket.
3. Check that the flow spout is open. NEVER PRESS FRUIT WHEN
THE POUR SPOUT IS CLOSED.
4. Wash the selected fruit or vegetables.
5. Press the I/O button to start the fruit extractor. The ring of blue
light will come on.
6. Lift the pusher and remove it from the feed tube. Insert the
food and push the food using the pusher, pressing firmly.
7. The juice will flow into the juice pitcher and the pulp will collect
in the pulp container.
8. When all the juice has been extracted, press the I/O button to
turn off the juice extractor.
9. Close the flow spout before removing the juice pitcher.