Beta 1498MN/12 Instrucciones página 9

Ocultar thumbs Ver también para 1498MN/12:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20
INSTRUCTIONS FOR USE
• Before starting the vehicle, turn off the lights and any running accessories.
• CAUTION: Never allow the clips of the two clamps (positive-red and negative-red) to touch together.
• CAUTION: Never reverse polarity. Always connect the output lead with red clamp (+) to the positive post of the
battery, and the output lead with black clamp (-) to the vehicle's chassis.
• CAUTION: REVERSED POLARITY CAN CAUSE AN EXPLOSION OR DAMAGE TO THE VEHICLE, THE PRO
DUCT AND PEOPLE.
• Improper use of the emergency booster or tampering with the built-in electronic circuit will invalidate your warranty.
HOW TO RECHARGE THE EMERGENCY BOOSTER
The emergency booster can be charged either through the wall charger supplied with it or the 12V car charger.
CAUTION: Recharge the emergency booster for at least 5 hours immediately after purchase, and after each use. If not in
use, recharge the emergency booster at least once a month, to keep the internal battery perfectly efficient.
Charging the emergency booster using the WALL CHARGER
1. Make sure that no device is connected to the emergency booster (see section Using the emergency booster as a power
source). Move the ON/OFF switch to the ON position and press button
2. Plug the 230V charger into the emergency booster socket.
3. Plug the charger into the 230V mains socket. The display will turn on, and the battery charge percentage will
show up. Charge is complete when the 100% indicator appears on the display.
4. Now the battery charger can be disconnected from the booster.
5. If not in use, recharge the emergency booster at least once a month for 5 hours, to keep the internal battery
perfectly efficient. The battery charger of the emergency booster is automatic.
CAUTION: Only use the charger that was included with the booster.
CAUTION: If the battery is not fully charged after 5 hours, the battery charger will automatically stop charging. If this should
occur, have the booster checked by a trained service centre.
Charging the emergency booster using the CAR CHARGER
1. Make sure that no device is conn ected to the emergency booster (see section Using the emergency booster as a power
source). Move the ON/OFF switch to the ON position and press button
(0% to 100%).
2. Plug either end of the CAR CHARGER into the emergency booster socket.
3. Start the vehicle; then plug the other end of the car charger into the 12V DC cigarette lighter socket of the vehicle.
The display will turn on, and the battery charge percentage will show up. The message "IN 15V 1A" indicates that
the recharging plug has been correctly plugged into the booster, and that the battery is charging. When the battery
is fully charged, both the message "IN 15V 1A" and the display will turn off.
4. Now the battery charger can be disconnected from the booster.
CAUTION: Always disconnect the emergency booster from the cigarette lighter socket if the vehicle's engine is not running.
1498MN_12.indd 9
to check the battery charging status (0% to 100%).
to check the battery charging status
EN
9
11/07/16 15:14

Publicidad

Tabla de contenido
loading

Tabla de contenido