Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
•
9/16" Socket Wrench (2)
Hitch Bracket Assembly
Assembling Hitch Bracket Assembly
1.
Insert the ends of the rear support bracket
through the narrow slots at the rear of each
side support bracket. See Figure 2-1.
2.
Secure folded tabs on rear support bracket to
side support brackets with a carriage screw (ref.
#9) and nylon lock nut (ref. #11). See Figure 2-1.
NOTE: The latches on the side support
brackets must be positioned with the opening
facing down on the outside of the bracket and
the tabs on the rear support bracket must be
facing up. See inset in Figure 2-1.
Figure 2-1
3.
Flip over bracket assembly and mount the pin
hitch support assembly (ref. #2) on the center
hole of the rear support bracket using the hex
screw (ref. #10) and flange lock nut (ref. #12).
See Figure 2-2.
NOTE: It may be easier to leave the hex
screw and flange lock nut only finger tight
until mounted on the mower to ensure
components properly align when installing on
mower.
4.
Attach the rubber grommet to the pin at the
bottom of the bracket support assembly. See
inset in Figure 2-2.
Figure 2-2
Required Tools
•
1/2" Socket Wrench (1)
Installing Hitch Bracket Assembly
If your mower is equipped with a K-62 transmission
you will need to remove the Hitch Support Bracket
(ref #4) from the Fast Attach Support Bracket
Assembly before mounting the hitch to the tractor.
To remove the bracket, use a T-30 torx drive to
remove the two torx screws securing the assembly.
See Figure 2-3.
Figure 2-3
1.
Flip complete hitch bracket assembly over
when ready to install.
2.
Pull back j-pins and lock open by twisting
them inward slightly and letting them rest
on the back of the rear support bracket. See
Figure 2-4.
Figure 2-4
3.
Slip the pin at the bottom of the bracket
support assembly into the hitch adapter on
the rear of the mower frame at a slight angle.
See 1 in Figure 2-5.
4.
Ease the hitch bracket assembly forward over
the shoulder bolts on the sides of the mower
frame. See 2 in Figure 2-5.
5.
Release the j-pins from the rear of the bracket
assembly. See 3 in Figure 2-5.
IMPORTANT! Make sure latches are fully
engaged with the shoulder bolts on the side
of the mower frame before attempting to
operate, or add any other attachment.
•
M10 Socket Wrench (2)
6.
Material Spreader Installation
1.
2.
3.
4.
•
T-30 Torx (If needed)
Figure 2-5
Fully tighten the hardware from step 3 if
previously left finger tight.
Attach the motor assembly to the bottom
inside of the hopper by threading four M6
x 20 bolts through and connecting with flat
washers and M6 locknuts. See Figure 2-6.
Figure 2-6
Slide the motor wire connector end through
the hole at the back of the hopper.
Fit the rubber grommet from the hardware
bag around the rim of the hole to keep
material from falling out.
Secure the spinner disc to the motor shaft with
a cotter pin. See Figure 2-7.
Figure 2-7
2
3
Publicidad
