Friedrich UCT08A10A Instrucciones De Operación página 9

Seal Installation
1. 1''x3/8''x25'' long seal in the center at the top of the sleeve. Remove the back paper and press into position.
2. 1''x3/8''x14'' seals to the left and right sides of the sleeve.
3. Cut 1''x3/8''x25'' long seals to 14'' long each and attach to the vertical sections of the grille as shown.
4. 1/2''x3 1/2''x1 1/2'' centering blocks one on each side wall. Place in center of side wall with the tapered end
facing the opening.
5. Gently slide unit into sleeve.
Ground Wire Installation
1. Install screw end of ground wire into inside of sleeve according to preparation instruction.
2. Before sliding unit all the way back remove second screw from left side of unit.
3. Remove plastic washer from screw.
4. Screw the other end of the ground wire into the unit as shown. Make sure the toothed washer is against the
cabinet.
5. Slide unit completely to the rear.
Non-Frigidaire Dual Intake Grille
In case where the existing sleeve is a non-Frigidaire sleeve but is installed with a dual intake grille, the existing.
grille may be left in place. Make sure the outer 3 1/2'' to 4 1/2'' louvers are angled from the left and right sides of
the sleeve toward the center, as Fig. 1 shows. This provides proper flow of outside air into the unit.
From the installation kit, apply two 1''x3/4''x14'' seals along the flat metal flange of the condenser, as Fig. 2 shows.
7