Installing The Handle; Reversing The Door - Klarstein Beerlager 88 Manual Del Usuario

INSTALLING THE HANDLE

The handle is supplied in a separate
package with screws inside the carton.
(1) Remove two small holes from the
door frame by pulling out the door seal
slightly. (2) Align the handle with the
holes and insert the screws from the
inside. (3) Tighten the screws with a
screwdriver. (4) Insert the door seal to
cover the screws.

REVERSING THE DOOR

• Open the door to 90 degrees and hold it tight.
• Loosen the two screws (1) from the lower right hinge (2) as shown in Figure 1.
• Slowly pull the door (5) outwards (see figure 2) to release from the lower hinge (2).
Then slowly pull the door (5) down to release it from the upper right hinge (4).
• Remove the lower hinge plate (3) from the door (see picture 2).
EN
21