Blade Gaskets; Allen Wrench - Emerson HF948BS02 Manual De Instrucciones

3. Ceiling Fan Assembly
3.6
Install and securely tighten the two 5/16-18 setscrews in
the motor yoke against the hanger pipe using the allen
wrench, supplied (Figure 6).
WARNING
!
It is critical that the setscrews are securely tightened.
Failure to verify that the setscrews are properly installed
(as shown in Figure 5) could result in the fan falling.
3.7
Slide the lower canopy down the hanger pipe and securely
tighten the setscrew on the lower canopy collar against the
hanger pipe using the supplied allen wrench (Figure 7).
3.8
CAUTION: Blades come in balanced sets of three. Do
not mix blades if installing more than one fan.
Install the three blade gaskets onto the motor assembly in
preparation of blade assembly (Figure 8).
(Continued)
CANOPIES NOT SHOWN
FOR CLARITY
MOTOR
YOKE
Figure 6
Figure 7
Figure 8
Please contact 1-800-654-3545 for further assistance
7
HANGER PIPE
5/16-18
SETSCREW (2)
ALLEN
WRENCH
HANGER PIPE
LOWER CANOPY COLLAR
LOWER CANOPY
SETSCREW

ALLEN WRENCH

MOTOR
ASSEMBLY
MOTOR ASSEMBLY
BLADE
GASKETS (3)
emersonfans.com
U.L. Model No.: HF948 & HF956