Special Programmes - Astralpool 45862 Manual De Instalación Y Mantenimiento

ELECTRICAL CABINET DUAL-SPEED PUMP / DIGITAL TIMER
GENERAL DESCRIPTION
This digital timer has been especially designed for use with a double speed pump.
Thanks to its programming capacity, the user can select the speed according to filtration needs with different
programmes depending on the day of the week and the bathing season, allowing an even greater energy saving and
giving the possibility of better filtration.
Likewise, the digital timer also includes the chance to use two specific programmes for maintenance of the filter.
The digital timer also includes an external input that stops filtration if this is necessary (motorised valves, water level
sensors, alarms...). This external input is ready for a signal of 12, 24 or 230 V in alternate or continuous current.
Note: The timer is supplied from the factory deactivated. The RST button should be pressed to activate it.
FUNCTIONING MODES OF THE DIGITAL TIMER
The digital timer can be used in two modes, MANUAL or AUTOMATIC.
The selection of these modes can be done at any time using the MAN/AUTO button.
• If the manual mode MAN is chosen, the user may choose the functioning speed: STOP (Stopped), ECO (Low) or
TURBO (High) using the STOP/ECO/TURBO button.
All the bars in the bar area (B) change the level according to the speed.
• If the AUTO automatic mode is chosen, the digital timer will give the operational orders according to the programme
entered by the user.
The digital timer shows all of the programming for the current period in the bar area (B)

Special programmes:

The digital timer includes two special programmes called BACKWASH and RINSE. To access these programmes, access
manual mode (MAN) and then press the button of the special programme.
SETTING THE TIME ON THE DIGITAL TIMER
After switching on, the time on the digital timer should be set. To do this, enter the season, day of the week and the time.
To set the season (high or low):
The PROG/OK button should be pressed (for approximately 4 seconds). Release the button and press the DAY/SEASON
button. The season logo will change.
To confirm the selection, briefly press the PROG/OK button.
To set the day of the week:
The PROG/OK button should be pressed continually, along with the DAY/SEASON button briefly, which will change the
day of the week.
To confirm the selection, briefly press the PROG/OK button.
To set the time:
The PROG/OK button should be pressed continually, along with the TIME button until the time shown on the screen is correct.
For fine adjustments of the time, briefly press the TIME button.
If the TIME button is held down, the speed that the time on the screen changes will accelerate.
To confirm the selection, briefly press the PROG/OK button.
Electrical cabinet Dual-Speed pump 5