Kuppersbusch FWK8800.0E Instrucciones De Uso E Instalación página 62

Shelves
To prevent damaging the door gasket, make sure to have the door all the way opened when pulling
shelves out of the rail compartment.
To remove shelves:
1. Fully extend the shelf you wish to remove (Fig. A)
2. Lift the front of the shelf up (Fig. A)
3. Holding the shelf track, push the shelf in, then up to release from the rear dampers (Fig. B)
Note:
 If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the
unit. If you attempt to restart before this time delay, the Wine Cooler will not start.
 When you use the wine cooler for the first time or restart the wine cooler after having been shut off
for a long time, there could be a few degrees variance between the temperature you select and the
one indicated on the LED readout. This is normal and it is due to the length of the activation time.
Once the wine cooler is running for a few hours everything will be back to normal.
Reversing the door
The door can be changed from left and right side. No special requirement, all the door is opened from
left side. If require to open from right side please refer to the following direction:
62