Kuppersbusch FWK8800.0E Instrucciones De Uso E Instalación página 65

 If you want to know the actual temperature, please press
will show actual temperature. After 5 seconds, it will show the setting temperature.
The controls of your wine cooler (the lower zone)

1) " " indicator light
Compressor in operation display.
2) LED display window
Display temperature for lower zone.
3) " " button (right)
To set the temperature of the lower chamber.
Press once the button, the temperature will increase 1°C.
4) " " button (right)
To set the temperature of the lower chamber.
Press once the button, the temperature will decrease 1°C.
Setting the temperature control

To set the temperature:
 When pressing
compartment automatically. The LED will flashing and display the setting temperature.
 Press once the button, the temperature will decrease or increase 1°C. When exceeding the
minimum value that can be established, it will jump to the highest adjustable temperature value
automatically. After stopping pressing the button for 5 seconds, LED figure will stop flash, then exit
setting model.
 The temperature setting can be adjusted from 10°C to 18°C.
Function instruction
 Temperature alarm:
If inner temperature is higher than 23°C, the "HI" is shown in display panel, and the buzzer alarm
after one hour continuously. It informs that the inner temperature is too high, please check the
reason. If inner temperature is lower than 0°C, the "LO" is shown in display panel, and the buzzer
alarm and the malfunction indicator light at the same time.
 Temperature recollection function:
In the event of a power interruption, wine cabinet will remember the previous temperature settings
and when the power is recovered, the cabinet temperature will go back the same setting
temperature as power off.
Internal light
In order to reduce energy consumption, this wine cabinet will automatically switch off the LED lights
after 10 minutes.
If you want the LED light to remain on continuously, this is possible. Please press and hold the
button for 5 seconds, the display will show "LP". After 4 seconds the display will revert back to normal,
and the light will remain on until manually switched off.
or button, the system will be entering the set up mode in the lower
or for 3 seconds, display panel
65