DITEC OBBI Manual Para La Instalacion Y La Manutencion página 14

OPERATING INSTRUCTIONS FOR SWING GATES AUTOMATION OBBI
RELEASE INSTRUCTION
In the event of a fault or blackout, release any electric lock, insert
the key and turn it anticlockwise (in the direction indicated by the
arrow on the gearmotor). Manually open the gate.
To block the door wings again, turn the key clockwise (in the
opposite direction to the arrow on the gearmotor). To facilitate
the operation, move the door wing slightly.
Attention: the door wing block and release operations must
be performed with the motor idle.
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential part
of the product and must be supplied to the user.
Read them carefully as they contain important indications for
the safe installation, use and maintenace.
These instruction must be kept and forwarded to all possible
future user of the system.
This product must be used only for that which it has been ex-
pressely designed.
Any other use is to be considered improper and therefore dan-
gerous.
The manufacturer cannot be held responsible for possible da-
mage caused by improper, erroneous or unresonable use.
Avoid operating in the proximity of the hinges or moving mecha-
nical parts.
Do not enter the field of action of the motorised door or gate
while in motion.
Do not obstruct the motion of the motorised door or gate as this
may cause a situation of danger.
Do not lean against or hang on to the barrier when it is moving.
Do not allow children to play or stay within the field of action of
the motorised door or gate.
Keep remote control or any other control devices out of the reach
of children, in order to avoid possible involuntary activation of
the motorised door or gate.
In case of breack down or malfunctioning of the product, discon-
nect from mains, do not attempt to repair or intervene directly
and contact only qualified personnel.
Failure to comply with the above may create a situation of
danger.
All cleaning, maintenance or repair work must be carried out by
qualified personnel.
In order to guarantee that the system works efficiently and cor-
rectly it is indispensable to comply with the manufacturer's indi-
cations thus having the periodic maintenance of the motorised
door or gate carried out by qualified personnel.
In particular regular checks are recommended in order to verify
that the safety devices are operating correctly. All installation,
maintenance and repair work must be documented and made
available to the user.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - ditec@ditecva.com
RIGHT PISTON
LEFT PISTON
ON
OFF
Installer: