Adjusting Resistance; Setting Clock; Explanation Of Buttons; Adjusting The Support Feet - Tunturi R20 Rower Manual Del Usuario

⚠ CAUTION
• If there are several heart rate measurement devices next to each
other, make sure that the distance between them is at least 1.5
metres.
• If there is only one heart rate receiver and several heart rate
transmitters, make sure that only one person with a transmitter is
within transmission range.
‼ NOTE
• Always wear the heart rate chest belt under your clothes directly
in contact with your skin. Do not wear the heart rate chest belt
above your clothes. If you wear the heart rate chest belt above
your clothes, there will be no signal.
• If you set a heart rate limit for your workout, an alarm will sound
when it is exceeded.
• The transmitter transmits the heart rate to the console up to a
distance of 1 metre. If the electrodes are not moist, the heart
rate will not appear on the display.
• Some fibers in clothes (e.g. polyester, polyamide) create static
electricity which can prevent accurate heart rate measurement.
• Mobile phones, televisions and other electrical appliances create
an electromagnetic field which can prevent accurate heart rate
measurement.
Maximum heart rate
(during training)
The maximum heart rate is the highest heart rate a person can safely
achieve through exercise stress. The following formula is used to
calculate the average maximum heart rate: 220 - AGE. The maximum
heart rate varies from person to person.
⚠ WARNING
• Make sure that you do not exceed your maximum heart rate
during your workout. If you belong to a risk group, consult a
physician.
Beginner
50-60% of maximum heart rate
Suitable for beginners, weight-watchers, convalescents and persons
who have not exercised for a long time. Exercise at least three times a
week, 30 minutes at a time.
Advanced
60-70% of maximum heart rate
Suitable for persons who want to improve and maintain fitness.
Exercise at least three times a week, 30 minutes at a time.
Expert
70-80% of maximum heart rate
Suitable for the fittest of persons who are used to long-endurance
workouts.
Use

Adjusting the support feet

The equipment is equipped with 2 support feet. If the equipment is
not stable, the support feet can be adjusted.
- Turn the support feet as required to put the equipment in a stable
position.
- Tighten the locknuts to lock the support feet.
‼ NOTE
• The machine is the most stable when all support feet are turned
fully in. Therefore start to level the machine by turning all
support feet fully in, before turning out the required support
feet to stable the machine.

Adjusting resistance

To increase or decrease resistance, turn the adjustment knob at the
top of the handlebar support tube clockwise (+ direction) to increase
resistance and counter-clockwise (- direction) to decrease resistance.
The scale above the knob (1-8) helps you find and set a suitable
resistance.

Setting clock

- Press and hold the MODE button and the RESET button for 2
seconds to reset the meter.
- Press the UP button or the DOWN button to set the clock.
Console (fig F)
⚠ CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered with drops of
sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger. Make sure that
your nails or sharp objects do not touch the display.
‼ NOTE
• The console switches to standby mode when the equipment is
not used for 4 minutes. If the console is in standby mode, the
display shows the room temperature

Explanation of buttons

Mode
Press the button to confirm your selection.
Start/ Stop
Press the button to start the training.
Press the button again to pause the training (max. 5 minutes).
Press the button again to continue the training.
Press and hold the button to stop the training.
2 1
English