Sony DVX-11A Instalación Y Conexión

Mobile DVD
Player
Installation/Connections
Instalación/Conexiones
DVX-11A
© 2003 Sony Corporation
1
1 2
4 5
7 8
qa
q;
3PM3 × 6
qd
× 3
3-255-986-31 (1)
Printed in Japan
3
6
3T5 × 8
× 4
9
× 4
qs
2
Front speaker (Left)
Altavoz delantero (Izquierdo)
Overhead monitor
Monitor portátil
Rear speaker (Left)
Altavoz trasero (Izquierdo)
Subwoofer
Altavoz potenciador de graves
Rear speaker (Right)
Altavoz trasero (Derecho)
3 Foot brake type
Tipo de freno de pedal
Parking brake switch cord
Cable de conmutación del
freno de estacionamiento
Using the tap
Uso de la derivación
Parking brake switch cord
Cable de conmutación del
freno de estacionamiento
9
Parking cord (Light green) of
Cable de estacionamiento (verde claro) de
Cautions
•This unit is designed for negative ground 12 V
DC operation only.
•Do not pinch wires under screws, or in moving
parts (e.g., seat railing).
•Before making connections, turn the car
ignition off to avoid short circuits.
•Connect the yellow and red power input leads
only after all other leads have been connected.
•Run all ground wires to a common ground
point.
•Be sure to insulate any loose unconnected
wires with electrical tape for safety.
•The use of optical instruments with this
product will increase the risk of eye injury.
•Control adjustments and procedures other
than those specified herein may result in
hazardous radiation exposure.
•For your safety, the monitor connected to the
FRONT VIDEO OUT can only be viewed when
the car is stopped and the parking brake
applied.
Be sure to connect the parking cord (Light
green) of 1 to the car's parking brake switch
cord.
Notes on the power supply cord (yellow)
•When connecting this unit in combination with
other stereo components, the connected car
circuit's rating must be higher than the sum of
each component's fuse.
•When no car circuits are rated high enough,
connect the unit directly to the battery.
Parts Iist (1)
The numbers in the list are keyed to those in the
instructions.
Installation diagram (2)
Example:
When installing under the passenger seat.
Note
All the equipment other than the Sony DVD player
DVX-11A and the remote control sensor is not
supplied.
Master unit
Unidad maestra
Remote control sensor
Sensor del control
remoto
Front speaker (Right)
Altavoz delantero
(Derecho)
Headrest Monitor
Monitor para reposacabezas
Sony DVD player DVX-11A
Reproductor de DVD DVX-11A de Sony
Connection box
Caja de conexiones
Hand brake type
Tipo de freno manual
Parking brake switch cord
Cable de conmutación del
freno de estacionamiento
c
1
1
Connecting the parking brake
cord (3)
Be sure to connect the parking cord (Light
green) of 1 to the parking brake switch cord.
The mounting position of the parking brake
switch cord depends on your car. Consult your
car dealer or your nearest Sony dealer for
further details.
Using the tap
Attach the tap 9 to the end of the parking cord
(Light green) of 1 and the parking brake switch
cord.
Note
If the parking brake switch cord is too thin, connect
the parking cord (Light green) of 1 to the parking
brake switch cord directly without using the tap 9.
Connection diagram (4)
1 To a metal surface of the car
First connect the black ground lead, then
connect the yellow and red power input leads.
2 To the +12 V power terminal which is energized
in the accessory position of the ignition key
switch
Note
If there is no accessory position, connect to the
+12 V power (battery) terminal which is
energized at all times.
Be sure to connect the black ground lead to a
metal surface of the car first.
3 To the +12 V power terminal which is energized
at all times
Be sure to connect the black ground lead to a
metal surface of the car first.
4 To the parking brake switch cord
5 To a digital amplifier or audio device
Connect the optical cable RC-97/98 (not
supplied), etc., to a digital amplifier or audio
device equipped with a Dolby digital decoder.