Tabla de contenido
Publicidad
8.
Install the Outside Panel
Front Panel Bottom Flange
Roller
Bride inférieure du panneau avant
Rouleau
Reborde inferior del panel frontal
Top Track
Rueda
Rail supérieur
Inside of Bath/Shower
Carril superior
Intérieur de baignoire/douche
Interior de la bañera/ducha
Outside Rail
Rail extérieur
Riel exterior
Installed Guide
Guide installé
Outside Panel
Guía instalada
Panneau extérieur
Panel exterior
NOTE: Perform these installation steps from outside the bath/shower.
Lift the outside door panel with the rollers facing you and position the rollers on
the outside rail.
Position the bottom of the door panel in the bottom track guide.
Check the panel for proper alignment and smooth operation. Adjust as needed.
Adjusting the Rollers
Remove the door panel.
Loosen the roller screw(s) and move the roller(s) to another hole in the hanger
bracket.
Reinsert and tighten the screws and reinstall the panel.
Install the Guide
Engage the guides in the front of the bottom track.
Slide the outside panel bottom flange into the groove of each guide.
Align the guide pin slot with the holes in the bottom flange.
Insert the guide pin through the guide pin slot and bottom flange hole. Push them
in until they snap into place.
1063218-2-B
Guide
Guide
Fit bottom frame flange
Guía
into groove.
Ajuster la bride du cadre
inférieur dans la rainure.
Encaje el reborde del
marco inferior en la ranura.
Guide
Guide
Guía
Bottom Track
Rail inférieur
Carril inferior
Fit this section of guide into bottom track.
Ajuster cette section du guide dans le rail inférieur.
Encaje esta sección de la guía en el carril inferior.
16
Guide Pin Slot
Rainure de la broche guide
Ranura para la clavija guía
Guide Pin
Broche guide
Clavija guía
Guide Pin Slot
Rainure de la
broche guide
Ranura para la
clavija guía
Sterling
Publicidad
Tabla de contenido
