Mex VIN4MS Manual De Instalacion Y Uso & Mantenimiento página 29

will be indicated by means of "H" on the
corresponding 7-segment display.
Heating up and cooling down will be
calculated dependent on
• The selected setting ("0" to "9")
• The ON/OFF time of the relays
• After switching OFF the cooking zone
the respective display shows "H" until
the assigned cooling zone temperature
is mathematically in an uncritical level. (<
60°C).
Automatic switch-off (limited operating
time)
Maximum operating time is defined for each
hob zone. The maximum operating time
depends on the selected cooking level (see
table). Once the maximum operating time
has expired, the hob zone is automatically
deactivated.
Each activation of the hob zone status
(modification of the cooking level etc.)
resets the countdown timer up to the initial
start value.
The timer settings have priority in relation
to the operating time limits, namely the
hob zone is turned off when the timer
has expired and not when requested by
the automatic power-off (e.g.: timer of 99
minutes at cooking level 9).
Protection against unintended switching
ON.
– If the electronic control detects continuous
operation of a key for approx. 10 seconds,
it switches OFF automatically. The control
sends out an audible failure signal for 10
seconds so that the user can remove the
object which has been mistakenly placed
onto the operation surface. The displays
show the failure code "ER03".
– If the failure carries on for more than
10 seconds, only the code "ER03" will
be displayed as long as the failure is
detected by the electronic control. If the
cooking zone is in the "hot" status, "H" will
appear on the display in alternation with
the failure signal.
– If no cooking zone is activated within 20
seconds after switching ON by means of
the Power-key, the control switches back
from the ON condition to stand-by mode.
– When the control is switched ON, the
ON/OFF Key has priority over all other
keys so that the control can be switched
OFF anytime, even in case of multiple or
continuous operation of keys.
– In the stand-by mode a continuous
operation will not be signalled. However,
before the electronic control can be
switched ON again, it has to recognize
that all keys are not operated.
Child safety lock (childproof function)
The child safety lock can only be activated
with the Touch Control on if no hob zones
are active and no timer has been selected.
It is therefore necessary to simultaneously
press the hob zone display of the front
right hob zone (FR) and the special Power
Booster (P), then press the display of the
hob area (FR) again. At this point all displays
show the symbol [L] denoting LOCKED
(=child lock against accidental activation).
Any hot hob zones warning lights [H] are
shown alternately to the symbol [L].
This procedure must be completed within 10
seconds and no other key must be pressed
except for that mentioned, otherwise the
procedure is cancelled because incomplete.
The electronics remain in the locked
condition until the key is released, even if in
the meantime the control unit was turned off
and turned back on again. Reinstatement
(disconnecting from the mains) of the
command does not remove the lock.
29
GB