Remote Control Operation - COOL AIR MK-TF0003 Manual De Instrucciones

OPERATION

REMOTE CONTROL OPERATION

RELEASE
PRESS
Prior to first-time operation, please remove the clear
plastic tab at the base of the remote and remove
plastic covering from the front of the face.
RELEASE
PRESS
FCC STATEMENT OF COMPLIANCE
This remote controller complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This remote controller has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measure:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
■ Consult the dealer or an experienced radio/TV technician for help.
POWER Turns Fan On/Off
SPEED SELECTION
Allows four different speed selections
OSCILLATION
Allows oscillation On/Off. See page
6 for more details.
WIND SELECTION
Allows for three different wind modes.
See page 6 for more details.
TIMER
Allows for automatic shut off after preset
time selections. See page 6 for more details.
REMOTE CONTROL BATTERY
REPLACEMENT
●
On the back of the remote, press the release button on
the bottom right hand side. This will allow the tray
containing the battery to be released.
●
Release the tray by squeezing the small clip and
pulling down the tab at the bottom of the remote
(Fig.1).
●
Replace the battery with 1 "CR2032"coin cell battery
and dispose of properly and in accordance with local
law and ordinances.
●
Slide the tab back into position until the tray locks
into the remote.
●
DO NOT DISPOSE OF BATTERY IN FIRE,
BATTERY MAY EXPLODE OR LEAK.
●
This product contains a button battery. If swallowed, it
could cause severe injury or death in just 2 hours.
Seek medical attention immediately.
●
For best performance we recommend using a
CR2032 battery.
~7~