Bluetooth Operation; Charging The Unit; Troubleshooting - Party Light & Sound PARTY-6LED Manual De Instrucciones

BLUETOOTH OPERATION

1. Turn on the unit and press the input selector button on unit to select the Bluetooth function.
2. Activate the Bluetooth feature on the external device to be paired.
3. Initiate a search for devices. The device shows up as "BT SPEAKER".
4. Press the   to start playing and the buttons  and  for the selection of songs.

CHARGING THE UNIT

This speaker has a high capacity battery. Please use the supplied USB lead for charging. You can connect it
to your smartphone charger, a USB port on your computer or a power bank. The indicator light will
illuminate red when the speaker is on charge. It takes around 6-8 hours to fully charge the speakers.
Disconnect the USB lead as soon as the battery is fully charged to avoid overloading the battery.
Note: When the battery of the speaker is low, please charge it within 48 hours. If you don't use the unit
for a longer period of time, please charge regularly the battery in order to avoid damage.
Trouble shooting
If a problem occurs, follow the steps in the table below. If problem still can't be solved, please contact your
retailer.
Problem
No sound when
power on
No sound from the
microphone
No sound after
inserting USB/SD
card
If Speaker makes
loud noises
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
©Copyright LOTRONIC 2017
Possible cause
1. No input source
2. Volume down
1. Bad mic connection
2. Mic not switched on
3. Mic volume down
1. Incorrect file format
2. Bad connection of USB/SD card
1. Microphone switched on but
may be too close to the speaker
2. Microphone switched on but is not
being used.
3. Microphone volume may be too
loud
4. Mobile phone is being used too
close to the speaker
5. Other wireless equipment may be
placed very close to the speaker.
Solution
1. Connect an AUX signal
2. Adjust volume
1. Plug in the mic properly
2. Switch mic on
3. Increase mic volume
1. File format should be MP3
2. Plug in USB/SD card properly
1. Keep the microphone 2
meters away from the speaker
2. Turn off microphone if not in use.
3. Adjust microphone
volume to lower mode
4. Keep mobile away from the
speaker whilst attending a call.
5. Keep the speaker away from
other wireless equipment
PARTY-6LED 5