Cleaning Impeller And Volute; Connections For Pump Operations; Manual Operation; Automatic Operation - Redlion RLWA SERIE Manual Del Propietário

MAINTENANCE

Cleaning Impeller and Volute

Periodic cleaning of the pump parts will prolong the life and
efficiency of the pump.
1. Remove the 4 bolts and 4 washers (1, 2) that secure the
motor housing (3) to the volute (4), then separate the
motor housing (3) from the volute (4).
s
WARNING
!
2.
housing cover. Warranty is void if the motor housing cover,
impeller or seals have been removed.
a. Any repair on the motor must be done by an authorized
Red Lion service center.
3. Clean the impeller (5) and the volute passage (6).
Do not use strong solvents.
s
CAUTION
!
a.
Removal of the impeller requires special tools and is to be
done only by an authorized service center.
4. Be sure the impeller turns freely after cleaning.
5. Attach the motor housing (3) to the volute (4) and secure it with
the 4 bolts and 4 washers (1, 2).
CONNECTIONS FOR PUMP OPERATION

Manual Operation

Disconnect the pump cord from the float switch extension and plug it
directly into the GFCI outlet.
s
CAUTION
!
This type of operation should be used
only for emergency use or when a large volume of water is to be
pumped. Pump must not be allowed to run dry. If pump is run dry, it
may damage pump and void the warranty.

Automatic Operation

Plug the pump cord into the float switch extension. Plug the float
switch cord (with pump cord attached) into the GFCI outlet.
8
Do not remove the motor
Do not remove the impeller.
3
5
6
4
2
A-N652
1
Manual
Operation
7
Automatic
Operation