Rf Channel Test; Radiophonic Listening" Function; Xr300 Siren Control - Hiltron security XR Serie Manual Para El Usuario

security
3.1.1

RF Channel Test

LED is lit
LED blinks
During this function, the "RET
This function allows to check the proper operation of peripheral radio devices.The XR500
utters some beeps whenever it receives signals from the connected devic with the System
Code programmed (if the System Code is not programmed, the "Roadiophonic Listening"
function is available only).

3.1.1.1 "Radiophonic Listening" function

Press "ESCLUSIONE" (Exclusion) Zone 1 button to start
"Radiophonic Listening" function to "listen" all noises in radiofrequency
and to convert them in audio signals and in short flashes of Zone 2 LED.
This function allows to know the optimum position where install the
Central Unit.(par. 2.2).
Press again "ESCLUSIONE" (Exclusion) Zone 1 button to disable
this function.

3.1.1.2 XR300 Siren Control

- Siren enabling
Press "ESCLUSIONE" (Exclusion) Zone 3 button to enable XR300
siren. The Zone 3 LED flashes.
- Siren desabling
Press the "ESCLUSIONE" (Exclusion) Zone 4 button to desable
XR300 Siren. The Zone 4 LED flashes.
Press "STATO ZONE / MEMORIA ALLARME"(Zone Status / Alarm Memory) to enter in the
next programming mode: Times Regulations.
antifurtoriginale.it
ST/BY
RETE
POWER
ASSENZA RETE MAIN POWER
INSERITO
ARMED
ALLARME
ALARM
FLASH:
MEMORIA ALLARME
MEMORY ALARM
XR500
E" (Network) LED is lit and "ALLARME" (Alarm) LED blinks.
24h
CENTRALE
CENTRAL
SENSORI
STATO ZONE
SENSORS
ZONE STATE
SIRENE
SIRENS
RX / TX
MEMORIA
ALLARME
ALARM
MEMORY
Programming
ZONE CONTROL
ON FLASH
ZONA APERTA ZONA ESCLUSA
ZONE ESCLUSED
ZONE OPENED
OFF LAMP: ZONA
ZONA CHIUSA ALLARMATA Zone alarmed
CLOSED ZONE
E X C L U S I O N
35